9
Obtaining Radio Codes using ODIS Select “Start Diagnosis”. When the Basic Vehicle Features box appears, deselect “Automatic” and select “Manual” for the vehicle identification.
Obtaining Radio Codes using ODIS
Select “Start Diagnosis”.
When the Basic Vehicle Features box appears, deselect “Automatic” and select “Manual” for the vehicle identification.
Obtaining Radio Codes using ODIS
When this box appears, press “Yes”.
After selecting the button, go to the “Model” drop down list and go all the way down until you see “Previous Models for Immobilizer-Online” and select it.
Obtaining Radio Codes using ODIS
This selection will automatically set all of the other selections as “All”. Next, deselect “Work with Guided Fault Finding” box and press the “Apply” button.
ODIS will now run a quick check and after when it is done, the “Special Functions” tab will appear on the top of the screen. Select this tap.
Obtaining Radio Codes using ODIS
After selecting this tab, you will see the “Checking Radio Code” test. Select this test and press the “Perform Test” button.
When you press the perform test, this box appears, just select “OK”.
Obtaining Radio Codes using ODIS
After pressing the OK button the test will now start. Press the “Complete/Continue” button.
On the next screen it will ask you for the VIN number. Enter the VIN in the “Red” box and select “Accept”.
Obtaining Radio Codes using ODIS
On this next screen, it will ask you for the “AUZ” number. Enter the AUZ number in the “Red” box and select “Accept”.
On this next screen, it will ask you for the “Client Name”. Enter name in the “Red” box and select “Accept”.
Obtaining Radio Codes using ODIS
On this next screen, it will ask you for the “Job Number”. Enter number in the “Red” box and select “Accept”.
On this next screen, it will ask you for the “Country of Origin”. Enter the country in the “Red” box and select “Accept”.
Obtaining Radio Codes using ODIS
After completing the vehicle and client information, this screen appears. Press the “Complete/Continue” button.
After pressing Complete/Continue, this login box appears. Enter your GEKO ID information in the box and select the “Apply” button.
Obtaining Radio Codes using ODIS
After pressing the button the test will start. The radio code retrieving test will go through a series of checks and steps in order to obtain the code. Some of the screens will show the following…….
The connection was established Next, the data will be sent. The data was transmitted.
The tester waits for data to be received. The tester evaluates the received data.
After the connection is established and the tester retrieved the radio code, this next screen will show up with your number. Press the Complete/Continue button to exit test.
