P/N 200648
EXISTING BAIL
HANDLE BRACKET200590
CABLE 923702
CABLE TIE 200359
BELT GUIDE 200624
BELT 54017
DECK BRACKET 200588
IDLER ARM 200558
PUSH RETAINER 200256
Manual insert for cable and belt upgrade on models C 18 and P 18 basic model and with seeder andbagger options.
C 18 BASIC MODEL
REV. B
P/N 200648
EXISTING BAIL
HANDLE BRACKET 200594FOLDING HANDLE 200590
CABLE 200580
CABLE TIE 200359
BELT GUIDE200624
BELT 540188 HP BELT 200602
DECK BRACKET200595
IDLER ARM 200558
P 18 BASIC MODEL
REV. B
P/N 200648
CABLE TIE 200359
BELT GUIDE200624
BELT 540188 HP BELT 200602
DECK BRACKET200595
IDLER ARM 200558
P 18 WITH BAGGER OPTION
BAIL 200586
CABLE 200580
HANDLE BRACKET 200599
REV. B
P/N 200648
Adjust belt guide as shown below. Gap between the belt guide and the pulley needs to be 1/16”
When you stand and pull the bail tight against the handle, the spring on the lower end of the cable mustbegin to stretch, and lengthen about an 1/8” to 1/4”. This ensures that the spring pressure is beingapplied to the belt to make it run without slipping. If you need to adjust the cable, loosen the tighteningnuts on the handle bracket and lengthen or shorten the cable until the proper adjustment is obtained,then retighten the nuts. Reinstall the belt shield.
INSTALL BELT GUIDEAS SHOWN, 1/16” FROMTHE PULLEY
REV. B