4
W62 RIG FOR WATER WELL AND ENERGY DRILLING ORNUNGA MASKIN & TEKNIK AB WELLDRILL
W62RIG FOR WATER WELL AND ENERGY DRILLING
ORNUNGA MASKIN & TEKNIK AB
WELLDRILL
SAFETY AND ERGONOMICS
To enhance safety, the machine has been designed with a semi-automatic safety guard and emergency stops accor-ding to EN16228. Operators are able to find their own ergo-nomic working position by utilizing the flexible remote control. Cable connected control panel as option. Advanced evacuation of pressurized air reduces noise and keeps the wor-king environment clean.Automatic functions and a hydraulic upper drill key give a fast and safe handling of the drill rods.
IDEAL FOR WORKING IN RESTRICTED SPACES
Our Welldrill W62 features a versatile crawler track platform with high ground clearance and 360° rotation. The rig is ideal for working in narrow and sensitive drilling sites. The operator controls the machine from a distance using a remote control panel. The panel provides for easy and safe adjustment of drilling performance.
LOW SERVICE AND OPERATING COSTS
Even the best equipment needs to be serviced regularly to make sure it sustains peak performance.
Working dimensions
Transport dimensions
2490
370
1700 6055
10,0˚10,0˚
5895
-689
5
1700
-110
– 8
90
10,0˚
Ornunga Maskin & Teknik ABKrangatan 22, 441 38 ALINGSÅS, SWEDEN
Phone: +46 (0)322 66 10 50Email: [email protected]: www.ornungamaskinteknik.se
Technical data
Weight Motor
Basic design complete unit 6750 kg Diesel engine Deutz, 55,4 kW TD3.6L4 Tier 4/Final
Rotation unit Electrical system
DHR6ED, serial/parallel function 24V
Speed 0-140/0-70 rpm Control system Sauer Danfoss PLUS+1/Scanreco
Maximum torque 2,7/5,4 kNm Communication CAN-bus
Carrier Cutting diverter
Crawler unit with rubber tracks Mounted on sled with hydraulic advance
Track width 400 mm Casing size 139/168 mm
2 travel speeds 2,5-4,8 km/h Casing size option 193 mm
Ground clearance 370 mm
Winch Volumes
Complete with cable, safety hook Hydraulic tank 110,0 l
and crown block. Hydraulic oil system total 165 l
Lifting capacity (maximum) 500 kg Fuel tank 108,0 l
Tram gear 1,3 l
Drill feed Lubrication oil tank 25,0 l
Feed force 30 kN Diesel engine 10,0 l
Pull back force 60 kN Rotation 11,0 l
Pipe rack Lubrication equipment
Hydraulic lift and advance, also used as support leg, Pressurized lubrication for DTH hammer
with space for 66 drill pipes (198 m). Diam. 76 mm
Option 83 drill pipes (249 m)
Selection of option
• Radio remote controlled hydraulic winch with towing eye and wire guides.• Cabel connected drill panel. • Bit holder for 6 drill bits.• Cutting diverter adapter for diameter 193 mm.• Spray gun for water pump.• Support leg plate holder (front/rear)• Water pump flow 30 l/min, 200 bar• Chain tongs• Welding unit, 380V 3-phase• Removable pipe rack extender (for totally 83 drill pipes, 249 m)• Removable drill hammer holder• Towing hitch
Caring and personal service
Our employees have a solid and broad experience in many technical areas, and you always get a personalized service of the highest quality!”Knowledge and experience together with a flexible attitude and a good team spirit make us the obvious choice for you as a customer”.
OM&T AB
