1
1 3 2 Multi Media Interface Multi Media Interface OPEL OPEL Micro Controller Micro Controller Adjust Adjust Audio 1 Audio 1 Audio 2 Audio 2 Audio Audio Video Converter Video Converter Power Power RGB input RGB input Video 2 Video 2 Adjust Adjust MONITOR MONITOR Camera Camera Video 1 Video 1 Audio 1+2 in / out Audio 1+2 in / out Monitor DATA Monitor DATA LVDS LVDS Ctrl Ctrl VIDEO 1 VIDEO 2 CAMERA RGB input RGB input V1 V1 Power Power V2 V2 CAM CAM DIP Settings DIP Settings Switch Switch Opel / Vauxhall Camera Video interface 12345678 DIP ON VIDEO 1 VIDEO 2 CAMERA POWER SUPPLY 1 2 3 4 5 6 7 8 UP (RGB input = OFF) UP = OFF / DOWN = VIDEO 1 active (white RCA) UP = OFF / DOWN = VIDEO 2 active (yellow RCA) UP (not used) UP = OFF / DOWN = rear CAMERA input active UP = standard / DOWN = when adjust image Horizontally IMAGE PROTOCOL (adjust when LCD stays black) UP = LCD 800x480 / DOWN = 480X240 RGB VIDEO 1 VIDEO 2 X CAMERA Image adj. Image adj. Image adj. 1 2 3 4 5 6 7 8 1. IDRV Swich 2. SPEED 3. LIGHT 4. REVERSE 5. ACC OUT 6. AIR CON 7. BATT 8. GND OUT 1. BATT 2. GND 3. CAN- 4. CAN+ Ground 12V (batt.) ~ ~ GMLAN ~ 1 2 3 Usually pin 14 LCD Cable from LCD Installation: - Connect the Y-adapter image cable of interface behind the 7” LCD. Take the org. Blue GVIF connector from the LCD and insert it into the Y-adapter. Connect the Y-adapter blue male connector directly to the LCD. When this has been installed correctly, the original image should be there. - Connect the power wires behind the radio head unit as shown below (quadlock). - Set the DIP switches as mentioned below. - Connect your external video sources with the right inputs. - Switch from OEM image to an external source by using the switch key or put gear in Reverse for the rear camera. Switch VIDEO 1 / 2 Only when interface is not reacting on reverse gear by GMLAN, cut the green wire between CANbox and interface and connect an analog stable +12V reverse signal directly to the green wire towards the big interface box. Only when interface is not reacting on reverse gear by GMLAN, cut the green wire between CANbox and interface and connect an analog stable +12V reverse signal directly to the green wire towards the big interface box. Compatible with: CD 500, NAVI 600, DVD 800, NAVI 900, NAVI 950
