Plaque mounting is very affordable comparedto other alternatives. There is no need forglare or glass. The print is attachedpermanently and it cannot wrinkle, fade orbuckle. The edges are finished with uniqueand different colors that allow activate aframe-free contemporary look allowing it tobe hanged on the wall.

In plaque mounting thereare several techniques thatare used as follows:

• Classic tape

• Self-adhesive backed photocorner.

• Dry picture mountingtechnique.

• Wet mounting method.

• Spray mounting method.

• When block mountingthose that providethese services willrequire the following:

• Measuring tape.

• Medium density fiberboard.

• Art print or photograph.

The following is step by step guidelines:

• First they, measure the photograph or art print then mark themedium density fiberboard. Cut the MDF using the carbideblade and using grit sandpaper cut the corners of the mediumdensity board.

• Then they build 1 by 1 cm thick frame which isplaced 2 inches from the corner of the boardat the back of the board that you are using.This will stop the board from flexing.

• Spray adhesive on the board and make sureyou don’t miss any single spot. Spray anothercoat after ten minutes and at the back of theposter, then swiftly place the poster on theboard as you attempt to center it.

• Using a straight edge tap the mounted posters moderatelyacross the board.

• After that, they leave it for up to 5-6 hours and then checkto make sure the poster has not lifted and it has roll andpress until the air pockets are not seen anymore.

Then they find polythene in a matte finish spray and spray it.They ensure the place is properly ventilated and that it is notsoaked. After 24 hours of drying they do the poly once again.

After 2 days, individuals inthis business head and checkto find out if the paper haslifted. Then utilizing a routerthat has a straight cuttingbit, they set a straight cornerguide which will leave with a1/8 gap. The gap is betweenthe corner of the poster andthe edge of the board.

• So as to have a nice bevelededge, one has to go round theedges using a 45 degree bitfor router. The poster iscovered leaving the freshlycut edge seaming exposed.

• Later, they get a spray paintand utilize it to spray thecorners of the MDF beforeremoving the tape.

• If you are looking for one ofthe best marketing ideas, youshould consider mountedposters.

You can also send your original photos through mail. If you are a local customer feel free to take the photos to their stores personally.