© 2019 it4powerCB 2019-10-14
OSMOSEImproving Interoperability Framework
Thomas Sterckx, ELIAChristoph Brunner, it4power
IEC 61850 Global – LondonOctober 15 – 17, 2019
© 2019 it4powerCB 2019-10-14
More information: https://www.osmose-h2020.eu/
© 2019 it4powerCB 2019-10-14
Task 7.1 - Interoperability
n Task will refine the interoperability framework based on the IEC 61850 ENTSO-E profile– High level definitions in the profile– Vendor-agnostic specifications– Vendor specific implementations
n Packages– Refinement of the ENTSO-E profile– End-to-end demonstration of IEC 61850 specification and
implementation– Promotion of results to IEC 61850 stakeholders
© 2019 it4powerCB 2019-10-14
Function specification – Phase A
n ENTSO-e ISTool is used to store and export TSO specific function/subfunction/signal
n Template is basic storage place of allocated functions and their connections to sig
n Export Templates as (enhanced) System Specification Description (SSD) file
© 2019 it4powerCB 2019-10-14
The functionality of the demonstrator
Storage System
Protection- Distance (3 zones)- Teleprotection (POTT)
Control- Control and monitoring
of switches
Breaker failure
Synchrocheck
Autorecloser
Measurements- Current- Voltage- Active power- Reactive power
Control- Control and monitoring
of switches- Check dead line – live
bus
Storage control- Active power control- Reactive power control
Algorithm for storage management (determine active and reactive power control)
Measurements- Current- Voltage- Active power- Reactive power
1p
Storage Storage
Other feeders; out of scope for demonstrator
© 2019 it4powerCB 2019-10-14
Demonstrator Setup
Demonstrator will be set up at R&D Nester facilities, Lisbon, Portugal
Using virtual IED concept Without using virtual IED concept
© 2019 it4powerCB 2019-10-14
Major extensions to SCL
n Introduction of the concept of Application in addition to function– A function may be used in different applications
n Extensions to the substation section for the specification– Introduction of source reference – similar to ExtRef– Introduction of the possibility to specify preconfigured values
(Instance data) in the specification (LNode)
© 2019 it4powerCB 2019-10-14
Example of function modeling