2
Sheet 1 of 2 DETAIL 01 DETAIL 01 DETAIL 05 DETAIL 03 DETAIL 04 DETAIL 02 DETAIL 03 DETAIL 06 KEY DETAIL 02 DETAIL 03 DETAIL 04 Data Sheet N° 201 Stainless steel and cable rail balustrade installation On Decking Substructure © © Copyright Greensquares Products Ltd 2013 Handrail End Cap Apply a bead of high strength retainer (supplied) to the male insert part of the fittings. Handrail bracket to be attached to pre drilled holes in the handrail using stainless steel screws supplied. Turnbuckles and fixings are indicative and may vary from those illustrated. End Post Turnbuckles and fixings are indicative and may vary from those illustrated. Refer to seperate guidance for turnbuckle fixing. Baseplate cover to slide over baseplate Baseplate to to be fixed with 2 holes to inside of balustrading and 1 hole to outside. Baseplate to sit on and fix through decking into double noggins on flat or trebbled up noggins. Baseplate fixed to timber using 3N° stainless steel M8x100mm coach screws (not supplied). Corner Post Apply a bead of high strength retainer (supplied) to the male insert part of the fittings. Handrail bracket to be attached to pre drilled holes in the handrail using stainless steel screws supplied. Handrail corner connector.
