Owner's manual - Sundown Audiosundownaudio.com/product-manuals/SAZ1000D_1500D_3000D.pdf ·...

SAZ-1000D

SAZ-1500D

SAZ-3000D

Owner's manual

-2-

Congratulations on your purchase of a Sundown Audio high performance car audioamplifier. Your new amplifier has been built to the highest standards of quality andis intended to serve you for years to come.

Visit us online at http://www.sundownaudio.com

WARRANTY:

Your new Sundown Audio amplifier is covered by a 2 year limited warranty ifpurchased from an authorized Sundown Audio dealer. This warranty does notcover improper installation, accidental damage, misuse, abuse, improperwiring, operation of unit outside of listed specifications, or any product thathas been modified or repaired by anyone other than Sundown Audio. Thiswarranty is transferrable provided the original invoice or receipt is stillwith the unit so that its new owner can prove date and place of purchase.

All warranty returns must be sent freight prepaid to Sundown Audio and beaccompanied by the original sales invoice or receipt. For faster warrantyservice please contact us at [email protected] to request areturn authorization code. At the sole discretion of Sundown Audio youramplifier will be either repaired or replaced.

If no defect is found and the unit must be shipped back the customer isresponsible for return freight, if the unit is truly defective the replaced orrepaired unit will be shipped back prepaid. In the event of shipping damagedue to improper packaging of the return the customer is liable for the costof all damages, necessary repairs, or replacement. Be sure to properly packyour return!

Sundown Audio also offers a 5 year guarantee to our customers for a discounted replacement unit. We are so certain of the quality of our equipment that even if you are at fault for causing damage to your amplifier we will offer you a new unit at a reduced cost compared to MSRP. Contact us via e-mail totake advantage of this offer, even though we doubt you will ever need to!This offer applies ONLY to the original purchaser of the unit and is nottransferrable like the 2 year limited warranty. As is the case with standardwarranty claims the return MUST be sent prepaid and with a copy of theoriginal invoice or receipt.

RETURN ADDRESS:

Sundown AudioATTN: WARRANTY SERVICE151 Rebel Hill DR.Mooresville NC, 28115

Features

-3-

Double Sided Through Hole Epoxy PCB

Daisy-Chain Through Output RCAEfficiency : 86% @ 4 ohm, at 100Hz24dB/Oct Variable CrossoverMulti-Way Protection Circuitry (Thermal/Over Current/Speaker Short/Speaker DC Protection)

Variable Subsonic FilterVariable Bass BoostVariable Low Pass FilterVariable Phase ShiftFour(4) Gauge Power Supply ConnectorsTested Voltage & THD : 14.4V & Less than 1% THDOperating Voltage : DC 10V~16V

Digital Class-D Linkable Mono Block Amplifier

1 Ohm Stability

RCA Line Input and Master Output24dB Octave Crossover Slope

Wired Remote Controller



Variable Subsonic FilterVariable Bass BoostVariable Low Pass FilterVariable Phase ShiftZero(0) Gauge Power Supply ConnectorsTested Voltage & THD : 14.4V & Less than 1% THDOperating Voltage : DC 10V~18V


1 Ohm Stability



SAZ-1000D

SAZ-1500D



Variable Subsonic FilterVariable Bass BoostVariable Low Pass FilterVariable Phase ShiftZero(0) Gauge Power Supply ConnectorsTested Voltage & THD : 14.4V & Less than 1% THDOperating Voltage : DC 10V~18V


1 Ohm Stability



SAZ-3000D

Rated power output -RMS power, 2 ohm linkable/dual mono ------ -RMS power, 1 ohm mono ------------------------ -RMS power, 2 ohm mono ------------------------ -RMS power, 4 ohm mono-------------------------Signal to Noise Ratio -----------------------------------Low pass frequency crossover ---------------------Subsonic filter ----------------------------------------------Bass boost @ 45Hz -------------------------------------Phase shift control----------------------------------------Frequency response--------------------------------------T.H.D @ 4 ohm----------------------------------------------Efficiency @ 4 ohm-----------------------------------------Fuse rating---------------------------------------------------Input Sensitivity -------------------------------------------Dimensions---------------------------------------------------

1800W x 1CH1000W x 1CH 600W x 1CH 300W x 1CH>90dB35Hz~300Hz10Hz~60Hz0~18dB0~180 degree10Hz~350Hz (+/- 1dB)<0.1%86%25A x 3200mV to 6V (+/- 5%)252(W) x 58(H) x 294(L)mm


6000W x 1CH3000W x 1CH1600W x 1CH 800W x 1CH>90dB35Hz~300Hz10Hz~60Hz0~18dB0~180 degree10Hz~350Hz (+/- 1dB)<0.1%86%300A (external type fuse)200mV to 6V (+/- 5%)252(W) x 53(H) x 594(L)mm

Specifications

SAZ-1000D

SAZ-1500D

SAZ-3000D


3000W x 1CH1500W x 1CH 800W x 1CH 400W x 1CH>90dB35Hz~300Hz10Hz~60Hz0~18dB0~180 degree10Hz~350Hz (+/- 1dB)<0.1%86%40A x 4200mV to 6V (+/- 5%)252(W) x 58(H) x 434(L)mm

-4-

MaxMin

GAIN

60Hz10Hz

SUBSONIC BASS BOOST

18dB0dB300Hz35Hz 1800

LPF

POWER

PROTECTION

CLASS-D LINKABLE MONO BLOCK amplifier

REMOTE

PHASE IN PUT BR OUT

BR ININ PUT

MaxMin

GAIN

60Hz10Hz

SUBSONIC BASS BOOST

18dB0dB300Hz35Hz 1800

LPF

POWER

PROTECTION


REMOTE

PHASE IN PUT BR OUT

BR ININ PUT

MaxMin

GAIN

60Hz10Hz

SUBSONIC BASS BOOST

18dB0dB300Hz35Hz 1800

LPF

POWER

PROTECTION


REMOTE

PHASE IN PUT BR OUT

BR ININ PUT

-5-

HEAD UNIT

Single Amp Input Connection

to SLAVE UNIT "BR IN"

* BR OUT (BRIDGEABLE OUTPUT)* BR IN (BRIDGEABLE INPUT)

Dual Amp Input Connection (MASTER & SLAVE RCA Connection)

"MASTER UNIT"

"SLAVE UNIT"

RCA Connection

HEAD UNIT



SAZ-1000D / SAZ-1500D / SAZ-3000D

POWER

SPEAKERGND REM B+

Caution

This amplifier is not supplied with internal fuse in itself. Make sure you install in-line fuse holder from the terminal of battery.

-6-

Power Connection

+12V PowerConnect the +12V terminal of the amplifier to the + terminal of the battery using a large gauge power wire (preferably 1/0 gauge). It iscritical to utilize an in-line fuse within 8 inches of the battery to ensure safe operation of the amplifier. Make sure that the fuse isnot installed while you are connecting the + wire to the battery terminal to avoid sparking and possible injury or damage.

GROUNDDisconnect the battery and connect the GND (ground) terminal to the cars chassis. Keep this cable as short as possible (not longer than 10 inches). Be certain that the chassis ground point is free of rust, paint, and grime to ensure a solid electrical connection.

REMOTEConnect the REM terminal to either the remote output lead from the radio or another switched 12V supply such as the power antenna wire.

First make the ground connection, then +12V wire connection and finally the remote connection. Furthermore, the +12V wire must always be fused at the battery for protection against possible damage. If you need to replace the power fuse, replace it with a fuse of the same value. It may result in a serious hazard to use a fuse of a different type or rating.

Caution

CautionThis amplifier is not supplied with internal fusein itself. Make sure you install in-line fuse holderfrom the + terminal of battery. Recommend 300 Ampere fuse.

To +12V DC

to REMOTE Turn-onfrom HEAD UNIT

CAR STEREO HEAD UNIT

GROUND

BATTERY

POWER

GND REM B+ FUSE

B+REMGND

POWER FUSE

SAZ-1000D SAZ-1500D

To +12V DC



GROUND

BATTERY

SAZ-3000D



GROUND

To +12V DC

BATTERY

POWER

SPEAKER OUTPUTGND REM B+ FUSE

BAB+REMGND

POWER FUSE POWER

-7-

1~4 ohms

++

--

++

--

2~8ohms

2~8ohms

To +12V DC



GROUND

BATTERY

SAZ-1000D

POWER


BAB+REMGND

POWER FUSE POWER

To +12V DC



GROUND

BATTERY

1~4 ohms

++

--

++

--

++

--

2~8ohms

2~8ohms

To +12V DC



GROUND

BATTERY

SAZ-1500D

To +12V DC



GROUND

BATTERY

Single Amp Power and Speaker Connection

++

--

POWER

SPEAKERGND REM B+

Caution


POWER

SPEAKERGND REM B+

Caution


-8-

1~4 ohms

++

--

++

--

++

--

Single Amp Power and Speaker Connection

2~8ohms

2~8ohms

300A (External Type Fuse)

Recommended Ampere

To +12V DC



GROUND

BATTERY


Recommended Ampere

To +12V DC



GROUND

BATTERY

SAZ-3000D

BAB+REMGND

POWER FUSE POWER

Dual Amp Power and Speaker Connection

-9-

Use 8 Gauge(AWG) wire cable

POWER


BAB+REMGND

POWER FUSE POWER

To +12V DC



GROUND

BATTERY

SAZ-1000D

POWER


To +12V DC



GROUND

BATTERY

To +12V DC



GROUND

BATTERY

SAZ-1500D

To +12V DC



GROUND

BATTERY

2~8 ohms


2~8 ohms

"MASTER UNIT"

"SLAVE UNIT"

"MASTER UNIT"

"SLAVE UNIT"

++

--

++

--

POWER

SPEAKERGND REM B+

Caution


POWER

SPEAKERGND REM B+

Caution



"MASTER UNIT"

"SLAVE UNIT"

2~8 ohms

-10-

Using a dual amplifier configuration, the MASTER amplifier has total control over the SLAVE amplifier. When using dual amplifier to operate subwoofer, the positive terminal of the subwoofer's voice coil must be connected to the positive terminal of the MASTER Amplifier and the negative terminal of the subwoofer's voice coil must be connected to positive terminal of the SLAVE Amplifier. Be advised that the dual amplifier configuration has tremendous output potential, so ensure that your subwoofers can handle such a large amount of power.

When utilizing the dual amplifier configuration it is important to note that the connected speaker load can be no lower than 2 ohms. Connecting a lower impedance load can damage the amplifier and void your warranty

Caution


Recommended Ampere

To +12V DC



GROUND

BATTERY


Recommended Ampere

To +12V DCto REMOTE Turn-onfrom HEAD UNIT


GROUND

BATTERY

Dual Amp Power and Speaker Connection

SAZ-3000D

++

--

This power amplifier has protection features to prevent any damages from misuse or faulty conditions. If the unit senses excessive heat, short circuited speakers or overload, the protection indicators will light, and the system will be turned off. In order to check the occurred problem, you should turn all levels down and all power off and carefully check the installation for wiring mistakes or short. If the amplifier shuts down due to excessive heat, the protection indicators will not light : simply allow time for the unit to cool.Before removing your amplifier, refer to the list below and follow the suggested procedures. Always test the speakers and their wires first.

PROTECTION LED ILLUMINATES WHEN AMPLIFIER IS POWERED UP

FUSE BLOWING

OVERHEATING

Check that the minimum speaker impedance is correct.

Check speaker shorts.

Check that there is a good airflow around the amplifier.

Check a good ground and for speaker shorts.

Disconnect all RCA inputs from the amplifier. If hiss/noise disappears, check

it with a good RCA interconnect. Then check the component driving the

amplifier.

SOUND TOO LOW-DISTORTED SOUND

Check that the input level control is set to match the output level of the unit.

Check the head unit volume.

Check speaker shorts.

Check that crossover frequencies have been properly set.

HIGH HISS-ENGINE NOISE IN SPEAKERS

Check that the minimum speaker impedance is correct.

Check short on power cable and vehicle chassis.

AMPLIFIER IS NOT POWERED UP

Check that there is battery power on the +12V terminal.

Check that remote terminal has at least 13.8V DC remote connection.

Check a good ground connection. Check all fuses.

Check the protection LED is not lit.

Check shorts on speaker wires.

Remove speaker wires and reset the amplifier. If the protection LED still

comes on, then the amplifier is faulty.

Trouble Shooting

-11-

MADE IN KOREA

Date post:	20-Apr-2018
Category:	Documents
Upload:	dinhkhanh
View:	221 times
Download:	4 times

Owner's manual - Sundown Audiosundownaudio.com/product-manuals/SAZ1000D_1500D_3000D.pdf ·...

Documents