PAG. K00398
CARACTERISTICAS CHARACTERISTICSPotencia instalada Power installed W. 1450Peso aprox. Aprox. Weight kgs. 90Peso dotacion productos incial Weight of products to start kgs. 60Medidas sin cuba enjuague Sizes w/o rinsing tank cms. 88,5x58,5x65,5Medidas con cuba enjuague Sizes with rinsing tank cms. 88,5x72x65,5Medidas embalaje Packing sizes cms. -
JUST CAST
2ndSTEP
1stSTEP
JUST CAST
1stSTEP
2ndSTEP
SILVER
GRINDING
SP-211POLISHING
SP-211 (2nd SILVER STEP) is a different machine, uses different compound, makes different work than PMG (1st SILVER STEP). PMG give better resaults in the outsides.
SP-211 2nd SILVER STEP REACHES RECESSED AREAS, INSIDES, FILIGREE AND JEWELS WITH STONES CAST IN PLACE.Does not affect stones, enamelling, and non conductive surfaces.
SP-211 makes now in a few minutes the MOST DIFFI-CULT WORK in finishing process, impossible for other automatic or mass processes, and very difficult and costly to do by hand. Easy. Automatic.
SP-211 makes your design much more free, since does not round prongs or angles and follows most accurately the contour of your design.
SP-211 can process practically all pieces normal in jewellery, even colliers or chains, enabling to process very heavy and very light pieces, at the same time.
SP-211 will: INCREASE your production, INCREASE your quality DECREASE your cost DECREASE your metal loss
RECOVERY THE METAL REMOVED - All metal removed will remain in the machine.
SILVER2ND STEP
BRASS
Tel. +34 93 3091707 Fax. + 34 93 3090702 e-mail: [email protected]
internet: http://www.hispanaspain.com C/ Can Cuiàs, 24-26 - Pol.Ind. Can Cuiàs, nave 20/1
Montcada i Reixac 08110 - Barcelona - España (Spain)
HISPANAde Maquinaria, S.A.
PAG. K00398d
1st STEP
PROCESS ON INSIDES, REACHES RECESSED AREAS, FILIGREE AND JEWELS WITH STONES CAST IN PLACE.
1 minuto - minute
PROCESS ON OPEN SURFACES
30 minutos - minutes
2nd STEP
SP211 PROCESS - SILVER - STEPS
Stamping
SP211 (2nd Step)
Very light buffing
Drying
Ultrasonds
Short buffing
GP10 - 50 min(1st Step)
Careful selectivegrinding
GP5 min.
Casting
Tel. +34 93 3091707 Fax. + 34 93 3090702 e-mail: [email protected]
internet: http://www.hispanaspain.com C/ Can Cuiàs, 24-26 - Pol.Ind. Can Cuiàs, nave 20/1
Montcada i Reixac 08110 - Barcelona - España (Spain)
HISPANAde Maquinaria, S.A.