Pages 1 removed
Irrelevant to request
Section 22(1)(a)(ii)
FOI Document #1
AGE' 'IROKER DETAILS (if applicable)
DESCRIPTION OF GOODS
(a) The description of the goods in the application will be used as the description of the goods in the TCO (if made). (b) The application should provide a full description of the goods, including the physical features of the goods or the various
components of the goods. It should not describe the goods in terms of what they do. (c) In accordance with section 269SJ of the Customs Act 1901, the CEO must not make a TCO in respect of goods:
(i) described in terms other than in generic terms; or (ii) described In terms of their intended end use; or (iii) declared by the regulations to be goods to which a TCO should not be extended. Goods will be taken to be described in terms other than in generic terms If, for example, their description, either directly or by implication, indicates that they are goods of a particular brand or model, or that a particular part number applies to the goods.
(d) Guidance on the drafting of the description of goods is contained In Volume 13 of the ACS Manual and in Australian Customs Notice No. 98/19.
1 Describe the goods
A4,g_fl1-4
ILLUSTRATIVE MATERIAL
2 Attach technical, illustrative descriptive material andlor a sample to enable a full and accurate Identification of the goods the subject of the application.
TARIFF CLASSIFICATION
3
Identify the tariff classification to 8 figure subheading level)
7 Identify the General Duty rate ,
If a Tariff Advice for the goods has been sought or obtained, please provide the TA No.
LEI or attach a copy. USES OF THE IMPORTED GOODS
4 Describe ALL uses (including design uses) to which the goods can be put.
A (I/I 1%4 — 0 (y 4.0 irl,t,io-e/I'v-C 6.61104.
Pages 3‐5 removed
Irrelevant to request
Section 22(1)(a)(ii)
FOI Document #1
'FP' Range of Explosionproof/Flameproof Certified Immersion Heaters
The 'FP' type flameproof electric heaters comprise a large range of process immersion heaters, certified for use in Zone 1 or Class 1, Div 1 Hazardous Area, custom-built to meet client specifications.
FEATURES
• Up to 1000kW.
• ATEX approved (g) 11 2 G/D.
• Certified EEx'd', Zone 1, Gas Group ILA, B, C.
• Certified Class 1, Div 1, Gas Group B, C, D.
• CENELEC, Standards Australia, CSA, FM.
• Terminal box is certified weatherproof to 11)66/67 or NEMA 7.
• Temperature classifications TT-T6.
• Elements are specially sealed to prevent moisture ingress.
• Elements are individually replaceable on site without the need for special tools.
• Withdrawable type elements are available to facilitate replacement without draining the vessel.
• Suitable and certified for use in high ambient temperatures e.g. Middle East.
Anti-condensation heaters fitted, if required.
TYPICAL APPLICATIONS
• Crude Oil / Hydrocarbon Liquids
• Glycol (TEG & MEG) Reboilers
▪ Molecular Sieve Regeneration
• Heat Transfer Oils
• Heating Medium
• Industrial Gases
• Tank Heating
• Natural Gas
• Fuel Gas
a Fuel Oils
• Water
02/03 2007 12:00 FAX 61 08 94307821 ICE WA
11008
ExheatO Electric Heaters & Control Systems HEAT
www.exheat.com
CE
FOI Document #2
. TOSUITANY APPtICATION TO.SUIT ANY
,A1PLIC.A1100 th.
BAEF LE SUPPORT
BAFFLE:SUriPORT.RODS
TERMINAL BOX
, PROCESS, FIXING.
. LIFTING EYE
1..kamo
MIN
THERMAL STAN OZFF
JUNCTION BOX
ROD ELEMENTS
NOMINAL FLANGE 5/TE W LOAD with a maximum immersed Len9f1) of 3665mM
inch mm I w/sq.ern 2.5 wisq,cm 7.44 wisq,cm
6 150 30 80 200
8 200 60 160 400
10 250 100 260 650
12 300 150 380 950
14 350 180 460 H50
16 400 245 620 1550
18 450 325 800 2000
20 500 400 980 2500
24 600 585 1460 3650
30 250 1 I 10 2780 5000
36 900 1610 4040 N/A
40 1000 1995 5000 N/A
Terminal
Manufactured from low temperature Carbon Steel or Gas Group IIC 316L Stainless
Box Steel throughout. with screwed or flanged lid to suit the hazardous environment.
Elements Manufactured from 80/20 NICr resistance wire with high purity compacted Magnesium Oxide powder sheathed within corrosion/erosion resistant tube. e.g.
lncoloy 800/825 " 316/316L Stainless Steel
▪ Inconel 600/625 • 321 Stainless Steel • Titanium • Monel
Internals Elements are supported in a baffle type support assembly to prevent vibration and element deformation.
Voltage Suitable for voltages up to 690v.
02/03 2007 12:00 FAX 61 08 94307821 ICE WA
Z007
Specification HEAT
HEATux Ltd Thrum, Road industrial 8sore, Watton, Thetford. Norfolk P25 6NG. UK. saleslibexhaatcom Oil & Gas Sales Tel: +44 10)1953 886201; Industrial Sales Tel -,94 (0) 1953 6E16210 Fax .44 )0)1953 886222
t.objecl to +NIVit:vottivut Mike
FOI Document #2
Document 1 RedactedPage 1Page 2Page 3
Document 2Page 1Page 2Page 3