OWD24 | 24” INDOOR/OUTDOOR WARMING DRAWER

24” I NDOOR / OU T DOOR WA RM I NG D R AWE R

O W D 2 4

G EN ER AL PRO PERTI E S

FINISH PANEL-READY

TECH N I CAL I N FO R MATI O N

ELECTRICAL REQUIREMENTS 120V/60HZ

TOTAL CONNECTED LOAD 120V/60HZ/15A

TOTAL AMPS 4 AMPS

UTILITY LOCATIONS RIGHT REAR ADJACENT CABINET OR BELOW INSTALLATION AREA

PRO D U C T D I M EN S I O N S

APPLIANCE DIMENSIONS (W X H X D) (IN.) 22 1/2" X 11 7/8” X 20”

CUT OUT DIMENSIONS (W X D) (IN.) 22 5/8” X 20 1/8”

DRAWER CAPACITY 1.33 CU. FT.AVAILABLE MODELS

24” Indoor/Outdoor Warming Drawer, Panel-Ready

◊ Electronic Control Panel.

◊ Four Temperature Levels—Proof, Low, Medium and High(100-200°). Temperature will automatically set to the lasttemperature setting used when the drawer is turned on.

◊ Four Timer Settings—1, 2, 3 & 4 hours plus an infinite timemode which keeps the warming drawer on until you turnit off.

◊ The Infinite mode is very useful when you need thewarming drawer on for extended periods of time likeduring parties and events or for use during the Sabbath.

◊ Blue LED Indicator lights.

FEATURES & BENEFITS

◊ Large Capacity.

◊ 50 pound weight limit.

◊ Quick to heat with 500 watt heating element.

◊ Approved for installation under Dacor wall ovens,microwaves, cooktops and in under counter applications.

OWD24

O P T I O N A L AC C E S S O R I E S

AWFP24SCH Silver Stainless Steel Panel, Chrome

OWD24 | 24” INDOOR/OUTDOOR WARMING DRAWER

CUTO UT D I M EN S I O N S

24” INDOOR/OUTDOOR WARMING DRAWER

I NDOOR/OUTDOOR UN ITS D IMENS IONS

M O D EL A B C

OWD24

- all specifications and information subject to change. please visit www.dacor.com for the most current product details and install information

-Warranty: Limited , parts and labor for one year

INDOOR/OUTDOOR UN ITS D IMENS IONS

M O D EL A B C D CUT O UT M I N .

OWD24 22 5/8” 24" *** 9 1/8” N/A 20 1/8"

HAN D LE D I M EN S I O N S

Chassis

Drawer open F

E

5/16”(8 mm)

BC

Overall Dimensions—IWD/OWD (top view)

40" (101.6 cm)3 prong

120 Vac power cord

Chassis withoutdrawer installed

Mounting hole,9 places

G

D

A

Drawer Face Dimensions—IWD/OWD

Chassis Dimensions—IWD/OWD

D E F G

22 1/2" 22 1/2" 22 1/2" 11 7/8" 20" 18" 11 7/8"

***OWD24 with optional factory front-panel kit only; minimum spacing shown to avoid scraping; gap above and below cutout is 3/4” min. (See ** above for OWD24 withcustom front panel); ****OWD24 cannot be installed above/below/adjacent to any model wall oven or warming drawer.