Parrot Bebop Drone GPS Board ReplacementThis guide will teach you how to properly remove and replace the GPS board on the Parrot Bebop

Drone.

Written By: Austin

Parrot Bebop Drone GPS Board Replacement Draft: 2017-05-25Guide ID: 77608 -

This document was generated on 2019-09-29 09:12:12 AM (MST).

© iFixit — CC BY-NC-SA www.iFixit.com Page 1 of 7

INTRODUCTION

This guide will show the steps needed to remove the GPS Module. In order to remove the GPSModule, the nose will have to be removed first. Removing the GPS Module will require disconnectingthe wire connections on it.

TOOLS:T5 Torx Screwdriver (1)Metal Spudger (1)

Parrot Bebop Drone GPS Board Replacement Draft: 2017-05-25Guide ID: 77608 -

This document was generated on 2019-09-29 09:12:12 AM (MST).

© iFixit — CC BY-NC-SA www.iFixit.com Page 2 of 7

Step 1 — Battery

Begin by removing the velcro strap around the battery.

Step 2

While holding onto the nose, gently pull the battery away from the nose.

Parrot Bebop Drone GPS Board Replacement Draft: 2017-05-25Guide ID: 77608 -

This document was generated on 2019-09-29 09:12:12 AM (MST).

© iFixit — CC BY-NC-SA www.iFixit.com Page 3 of 7

Step 3

Once the battery is separated from the nose, push down on the connector and pull the batteryaway from the connector.

Step 4 — Styrofoam Nose

Remove the two 7mm T5 torx screws using a screwdriver. There is one located on each side.

Parrot Bebop Drone GPS Board Replacement Draft: 2017-05-25Guide ID: 77608 -

This document was generated on 2019-09-29 09:12:12 AM (MST).

© iFixit — CC BY-NC-SA www.iFixit.com Page 4 of 7

Step 5

Take the metal spudger, to removethe double stick tape from the foam.

Step 6

Remove the styrofoam nose fromover the drone's camera by sliding ittowards the front of the drone at anangle.

Parrot Bebop Drone GPS Board Replacement Draft: 2017-05-25Guide ID: 77608 -

This document was generated on 2019-09-29 09:12:12 AM (MST).

© iFixit — CC BY-NC-SA www.iFixit.com Page 5 of 7

Step 7 — GPS Board

Remove the cable from the top ofthe GPS module.

Step 8

Remove the two 6mm T5 torx screws holding the GPS module. There is one screw on each side.

Remove the 4mm T5 Screw holding the GPS Module.

Parrot Bebop Drone GPS Board Replacement Draft: 2017-05-25Guide ID: 77608 -

This document was generated on 2019-09-29 09:12:12 AM (MST).

© iFixit — CC BY-NC-SA www.iFixit.com Page 6 of 7

To reassemble your device, follow these instructions in reverse order.

Step 9

Remove the GPS board by lifting itoff of the metal frame.

Parrot Bebop Drone GPS Board Replacement Draft: 2017-05-25Guide ID: 77608 -

This document was generated on 2019-09-29 09:12:12 AM (MST).

© iFixit — CC BY-NC-SA www.iFixit.com Page 7 of 7