1
PARTS SEPARATOR Kral11l'rllldustril's Inc., N. Y. Rotary screen separators from Kramer Industries offer complete, rapid separation of parts and me- dia. The openings cannot be blinded by media or parts as would a flat-bed screen. Parts are turned over to spill out all media. Three sizes are avail- able: the TRS-1 for up to 6 ft:l vibrators; the TRS-2 for large vibrators or tumblers; and the TRS-2D two-stage separator for removing fines and sepa- rating at the same time. Circle 159 on reader information card SMALL FINISHING SYSTDIS AE. Aubin Co., Conn. Aubin's Ty-nee Power Units are the quiet. versa- tile solution to small parts finishing needs. The varying shapes and sizes of the barrels and bas- kets allow for a wide range of operations including cleaning, deburring, separating. stripping, polish- ing. or coating. Both Model 510 and 1600 are driven by aIlS V/60 Hz electric motor. Model 510 weighs only 6 lb with a load capacity of 5 lb. Model 1600 weighs 15lb and has a load capacity of20 lb. Each model requires less than 2 ft2 of bench space. Circle 160 on reader information card MASS PlNISHING Turbo-Finish Process Laboratories, Bartlett. N.H. Turbo-Abrasive Machining and Turbo-Polishing Processes and Equipment can be used to automate deburring and edge contour processes on many types of rotating components. The process is char- acterized by very rapid cycle times and the ability to develop sophisticated edge and surface finishes with a minimum of direct labor and is especially well suited to single-piece continuous-flow opera- tions. Circle 161 on reader information card December 1999 25
