+ All Categories
Home > Technology > Pavement Marking Equipment

Pavement Marking Equipment

Date post: 11-Jul-2015
Category:
Upload: glenn-mahaffey
View: 1,008 times
Download: 0 times
Share this document with a friend
Popular Tags:
15
Vacuum system can be mounted on rear of unit.
Transcript
Page 1: Pavement Marking Equipment

Vacuum system can be mounted on rear of unit.

Page 2: Pavement Marking Equipment

Floating head (shown in center position) can be used on right hand and left hand of machine

Page 3: Pavement Marking Equipment

Operator can see work area easier.

Page 4: Pavement Marking Equipment

Floating head can hold up to 13” wide blade set.

Page 5: Pavement Marking Equipment

Toolcat makes an excellent unit for the floating head.

Page 6: Pavement Marking Equipment

Floating Head Rider Saw with vacuum proven productivity.

Page 7: Pavement Marking Equipment

Built strong for a long service life.

Page 8: Pavement Marking Equipment

8” wide Floating Head show with a 5” extender. Up to 13” total width. Manual adjusters optional.

Page 9: Pavement Marking Equipment

Plunge cut unit for marker installation fits any skid steer or can be truck mounted.

Page 10: Pavement Marking Equipment

Cutting head can be installed on right or left hand side with 5 minute change over.

Page 11: Pavement Marking Equipment

Cutting head is self-leveling.Conforms to the road surface.

Page 12: Pavement Marking Equipment

Dust box remains at road level while cutting head goes down and up.

Page 13: Pavement Marking Equipment

Operator can see work area.

Page 14: Pavement Marking Equipment

Positive stop. Once you set your stop, you can never cut too deep or not deep enough.

Page 15: Pavement Marking Equipment

Disconnects completely from the machine in less than 3 minutes.


Recommended