+ All Categories
Home > Documents > #7183 Sway Bar Set - Pro Rally Supplement Bar Pivot Cap 7.5mm 7183 Sway Bar Rod End 25225 3 x 3mm...

#7183 Sway Bar Set - Pro Rally Supplement Bar Pivot Cap 7.5mm 7183 Sway Bar Rod End 25225 3 x 3mm...

Date post: 05-Feb-2018
Category:
Upload: trinhkhanh
View: 221 times
Download: 0 times
Share this document with a friend
1
#1596 thread lock 25225 3 x 3mm Set Screw 7183 2 x 6mm SHCS BUILD x4 x2 x2 NOTE: Snap sway bar ends into links. NOTE: Loosen the four button head screws holding the top of the gear case in place in order to install the sway bar. Re-tighten screws once the sway bar is in place. NOTE: Mount swaybar ball ends flush with ends of sway bar. NOTE: Tighten the two socket head screws while still allowing free movement of the sway bar link. NOTE: Do not overtigten set screws, the sway bar should be able to move freely. NOTE: Make sure the suspension travels freely when Sway Bars are installed. Adjust the sway bar stud to allow for clearance around the drive shafts and linkages. Everything should be able to move freely and with no obstruction. ! ! ! ! ! ! 7183 Sway Bar Pivot Ball 7183 Sway Bar (2.0 - Front) (1.8 - Rear) 7183 Sway Bar Stud 7183 Sway Bar Pivot Cap 7.5mm 7183 Sway Bar Rod End 25225 3 x 3mm Set Screw x2 x2 #7183 Sway Bar Set - Pro Rally Supplement
Transcript
Page 1: #7183 Sway Bar Set - Pro Rally Supplement Bar Pivot Cap 7.5mm 7183 Sway Bar Rod End 25225 3 x 3mm Set Screw x2 x2 #7183 Sway Bar Set - Pro Rally Supplement. Title: 7183.indd Created

#1596

thread lock

252253 x 3mmSet Screw

71832 x 6mm

SHCS

BUILD x4

x2

x2

NOTE:Snap sway bar ends into links.

NOTE:Loosen the four

button head screws holding the top of the gear case in place in order to

install the sway bar. Re-tighten screws once the sway bar

is in place.

NOTE:Mount swaybar

ball ends flush with ends of sway bar.

NOTE:Tighten the two socket head

screws while still allowing free movement of the sway bar link.

NOTE:Do not overtigten

set screws, the sway bar should be able to move freely.

NOTE:Make sure the suspension travels freely

when Sway Bars are installed. Adjust the sway bar stud to allow for clearance around

the drive shafts and linkages.Everything should be able to move freely

and with no obstruction.

!

!

!

!

!

!

7183Sway Bar Pivot Ball

7183Sway Bar

(2.0 - Front)(1.8 - Rear)7183

Sway BarStud

7183Sway BarPivot Cap

7.5mm

7183Sway BarRod End

252253 x 3mmSet Screw

x2

x2

#7183 Sway Bar Set - Pro Rally Supplement

Recommended