SERVICE Whirlpool EuropeCustomer Services
8593 972 29080, 09/15/08page 22 of 29
PENDANT LE PROGRAMME TEST
© Whirlpool Europe www.scc-service.com
SERVICE Whirlpool EuropeCustomer Services
8593 972 29080, 09/15/08page 23 of 29
CODE ERREUR
© Whirlpool Europe www.scc-service.com
SERVICE Whirlpool EuropeCustomer Services
8593 972 29080, 09/15/08page 24 of 29
CODE ERREUR
© Whirlpool Europe www.scc-service.com
SERVICE Whirlpool EuropeCustomer Services
8593 972 29080, 09/15/08page 25 of 29
CODE ERREUR
© Whirlpool Europe www.scc-service.com
SERVICE Whirlpool EuropeCustomer Services
8593 972 29080, 09/15/08page 26 of 29
CODE ERREUR
© Whirlpool Europe www.scc-service.com
SERVICE Whirlpool EuropeCustomer Services
8593 972 29080, 09/15/08page 27 of 29
CODE ERREUR
© Whirlpool Europe www.scc-service.com
SERVICE Whirlpool EuropeCustomer Services
8593 972 29080, 09/15/08page 28 of 29
SERVICE BULLETIN
4812 712 40313
AUTHOR: Juergen ReinhardtLAST_UPDATE: 08/13/08VERSION: 1.0
TITLE: F06 randomly displayed in Domino controls
CAUSE:
Sensible failure detection in drive system for safety reasons
REMEDIAL ACTION:
Please check the following points:
Load:
Was there bulky load in the drum or was the machine overloaded ?
Drive system:
Please check the tacho generator (resistance and cable).
Please guarantee a proper and tight seat of the belt on drive shaft and pulley.
Please check the electrical connections between controls and motor.
© Whirlpool Europe www.scc-service.com
SERVICE Whirlpool EuropeCustomer Services
8593 972 29080, 09/15/08page 29 of 29
SERVICE BULLETIN
4812 712 40302
AUTHOR: Ronny SchurrichtLAST_UPDATE: 06/03/08VERSION: 1.0
TITLE: Drum up function not working.
ISSUE:
We have some claims related to toploaders with drum up function not working. That means, atthe end of cycle the drum stops with drum door in wrong position.Reason is a software bug in the control unit.In production the problem is solved since week 12 / 2008, means serial number of machines from340812xxxxxx onwards.
REMEDIAL ACTION:
In case of such a claim, the control board needs to be reprogrammed by SAM module with thedatabase DB-2062.
© Whirlpool Europe www.scc-service.com