+ All Categories
Home > Documents > Perry Lapper Progress. Frame With Actuators Outside Frame.

Perry Lapper Progress. Frame With Actuators Outside Frame.

Date post: 02-Jan-2016
Category:
Upload: dorothy-kelley
View: 214 times
Download: 0 times
Share this document with a friend
Popular Tags:
17
Perry Lapper Progress
Transcript
Page 1: Perry Lapper Progress. Frame With Actuators Outside Frame.

Perry Lapper Progress

Page 2: Perry Lapper Progress. Frame With Actuators Outside Frame.

Frame With Actuators

Page 3: Perry Lapper Progress. Frame With Actuators Outside Frame.

Outside Frame

Page 4: Perry Lapper Progress. Frame With Actuators Outside Frame.

Actuators with Servos

Page 5: Perry Lapper Progress. Frame With Actuators Outside Frame.

Doing Work

Page 6: Perry Lapper Progress. Frame With Actuators Outside Frame.

Right Side Motors

Page 7: Perry Lapper Progress. Frame With Actuators Outside Frame.

Parker Servo Motor

Page 8: Perry Lapper Progress. Frame With Actuators Outside Frame.

Between Actuators

Page 9: Perry Lapper Progress. Frame With Actuators Outside Frame.

Actuator Mounting Screws

Page 10: Perry Lapper Progress. Frame With Actuators Outside Frame.

Slide Bearing

Page 11: Perry Lapper Progress. Frame With Actuators Outside Frame.

Casters and Adjustable Bearings

Page 12: Perry Lapper Progress. Frame With Actuators Outside Frame.

Mess ups• Several Parts machined were out of tolerance• On the bottom steel Conveyor Frame one bearing hole set was

messed up• On the gear train assembly the tolerances were off and several of the

pieces wouldn’t fit together. • Jack Plates were drilled upside down. The mounting holes were on

bottom of one plate of each of the 4 assemblies.• Extra strap welded into adjustable bearing mount keeps conveyor

roller from being installed. • Press hole for Bearings in gear train too small. Bearing will not press

in as hole is 22 thousands too small. • Slip Hole for shafts for gear train machined to exact size of hardened

pins. At least 2 thousands required to slip fit pins.

Page 13: Perry Lapper Progress. Frame With Actuators Outside Frame.

Fixing Parts

Page 14: Perry Lapper Progress. Frame With Actuators Outside Frame.

After Drill and Mill thru Holes

Page 15: Perry Lapper Progress. Frame With Actuators Outside Frame.

Needs Drilled and Tapped

Page 16: Perry Lapper Progress. Frame With Actuators Outside Frame.

Lower Section CountersinkNot Deep Enough

Page 17: Perry Lapper Progress. Frame With Actuators Outside Frame.

Look here for updates

Your partner in Automation


Recommended