Date post: | 21-Jan-2016 |
Category: |
Documents |
Upload: | margaret-todd |
View: | 212 times |
Download: | 0 times |
Phase Two Titration Year 10 EEI by Mr H Graham
Volumetric analysis is;
A type of chemical analysis which depends on the accurate measurement of solution volumesA titration is a
form of volumetric analysis
Phase Two Titration Year 10 EEI by Mr H Graham
Phase Two Titration Year 10 EEI by Mr H Graham
Phase Two
This Friday we will carry out a titration using a 2g sample of the white powder mix
The white powder contains sodium carbonate. This will be titrated with a standard (known concentration) hydrochloric acid solution. By measuring the volume accurately and by using n = cV we can find the number of moles of hydrochloric acid reacting and by using the reaction ratio find the number of moles of carbonate in the original mix
Phase Two Titration Year 10 EEI by Mr H Graham
BUT!
WHAT DOES A TITRATION LOOK LIKE?
Phase Two Titration Year 10 EEI by Mr H Graham
TITRATION ANIMATION
REQUIRES WEB LINK
HERE
Phase Two Titration Year 10 EEI by Mr H Graham
Titration equipment
pipetteaccurately measures smaller volumes (25mL)
burette a graduated tube with tap. Used to measure volumes of solutions during a titration
Research, How they are used.
Phase Two Titration Year 10 EEI by Mr H Graham
Titration equipmentvolumetric flask
accurately measures a set volume (100mL)
pipette filler
a device that is used to draw solutions safely into a pipette
Research, How they are used.
Phase Two Titration Year 10 EEI by Mr H Graham
ProcedureDissolve two grams of white powder in about 40mL of H2OPour this into a 100mL volumetric flask. Add distilled water so that you get up to the 100mL mark. This solution has an unknown concentration.
Set up a clean burette using a burette stand. Use a funnel and fill this with the hydrochloric acid solution (known concentration 0.1M)
Pipette 20mL of the white powder solution into a conical flask. Add 4 drops of methyl orange indicator (this will turn yellow)
TITRATE by adding the acid solution from the burette into the conical flask. You will notice a pink colour appearing as the acid is added. Proceed slowly
STOP and RECORD the volume of acid
When the indicator changes to all PINK (END POINT)
USE n =c V to find the number of moles of acid added
COPY THIS
Phase Two Titration Year 10 EEI by Mr H Graham
white powder mix has high pH at the start of the titration
by adding acid from the burette the pH drops. The indicator changes when the reaction is complete
Phase Two Titration Year 10 EEI by Mr H Graham
Phase Two Titration Year 10 EEI by Mr H Graham
The unknown Na2CO3 is titrated against an known HCl solution. 20mL of the carbonate is placed in the conical. The known (0.1M) HCl in the burette.
An average titration reading of ? is obtained.
What is the concentration of the carbonate solution?
2H+ + CO3
2- = CO2 + H2O
Consider your titration, we know three key things we need to calculate the acid concentration
a simplified form of the equation, notice the 2 : 1 ratio
Phase Two Titration Year 10 EEI by Mr H Graham
2HCl + Na2CO3 2NaCl +CO2 + H2O
Consider your titration, we know three key things we need to calculate the acid concentration
HCl = 0.1Mvolume ? burette reading
Na2CO3conc unknownvolume =
20mL(0.02L)
Find moles of HCl
Find moles of carbonate in 20mL of solution (half moles of HCl)
Find how many moles of carbonate in 100mL volumetric flask
This is the number of moles in 2g of white powder
Find the number of moles in 5g of powder
Find mass of Na2CO3 in 5g
2 1