VB
3-T-
063-
en -
03/1
7
PHILIPP Wire protection pulley
Application Instruction
for Cast-in lifting hoops
2© 2017 PHILIPP GmbH, 63741 Aschaffenburg • Technical changes and errors reserved • March 2017
PHILIPP Wire protection pulley
Table 1: DimensionsRef.-No.
Wire protection pulley
Type ØD ØDR (ØDR S)
S.max N B b Weight for Cast-in lifting hoop
[mm] [mm] [mm] [mm] [mm] [mm] [kg/pc.] Type
44SR008020 2.0 9.0
0.8 Pure white
Light pink 2.0 Pastel green
Jet black 4.0
CurryLight blue
84.0 24.0 42.0 2.90
8.0 Silver greyClaret violetSulfur yellow
Blue lilac20.0 Beige
Clay brown
202 44.0
28.0 Pure whiteJet black
Salmon orange42.0 Salmon orange
Salmon orangeSalmon orange
99.0 98.0 29.00
Salmon orangeSalmon orangeSalmon orangeSalmon orange
99.0 Salmon orange
The Wire protection pulley is an accessory for the PHILIPP -
tively to ensure the capacity of the Cast-in lifting hoop.-
Wire protection pulley as a system-
tion pulley is also available as a complete set. This consists of:
a Wire protection pulley
a high strength shackle with eye bolt
a master link
Table 2: System componentsRef.-No.System- complete
Wire protection pulley[Type]
Shackle
[Nominal size]
Master link
[Nominal size]44SR008020K 2.0 2.0
A22
A40-
99.0 -
b
ØD
R N B
S.max
ØD
PHILIPP Wire protection pulley
3 © 2017 PHILIPP GmbH, 63741 Aschaffenburg • Technical changes and errors reserved • March 2017
Technical Information / Application
Application
Attention: Cleaning of the components and visual in-spection for damages and inadmissible wear! If such impairments are detected the components must be marked as inoperative and must not be used anymore.
Positioning of the Wire protection pulley parallel to the wire rope of the Cast-in lifting hoop.
Attention: If the elements’ surface is sloped the Wire protection pulley must be prevented from inadvertent rolling.
Technical information ---
--
By using the Wire protection pulley the given ra-
Cast-in lifting hoops are met.
Advice: Preferably, this step runs from the side, as the master link can be put down here on the concrete sur-face.
Positioning of shackle eyes axial to the Wire protection
inspection of centric position of the Cast-in lifting hoop in the groove of the Wire protection pulley.
Picture 4
Picture 2