Date post: | 23-Jan-2018 |
Category: |
Technology |
Upload: | seminarppts |
View: | 1,470 times |
Download: | 0 times |
A THECHNICAL PRESENTATION
ON
“PLASTIC BRICKS”
By
Sk.M.Rahamath Shareef
1
INTRODUCTION
PREPERATION PROCESS
ADVANTAGES
DISADVANTAGES
FUTURE SCOPE
REFERENCES
CONTENTS
2
plastic waste is increasing due to increase
in population, urbanization and
development
The disposal of waste plastic has become
a serious problem globally due to their
non-biodegradability.
INTRODUCTION:
3
PREPERATION PROCESS:
Collecting the wasteplastic
Melting the mixture
Mixing
Moulding
Drying4
COLLECTING THE WASTEPLASTIC:
Bags and bottles
Plastic covers
Buy them from middle-men who collect 5
MELTING THE MIXTURE:
a simple drum(sheet metal )
safety equipment,
including eye protection,
breathing apparatus, gloves,
6
MIXING:
Coarse Sand is added and mixed in up to
a smooth consistency .
7
MOULDING:
Metal moulds.
Different
shapes.
8
DRYING:
Placed In The Sun To Dry For Up To 24 Hours.
9
THE TEAM WHO PREPARED “PLASTIC BRICKS”
10
Low Cost
Eco Friendly
High Strength
High Profit
Creating Jobs
ADVANTAGES:
11
Less fire resistant
Release of harm full gases at time of preparation
DISADVANTAGES:
12
FUTURE SCOPE:
Establishing the industries.
Increasing their strength by adding other material.
Recycling the plastic and using as a construction material.
Protection of environment.
13
PUBLISHED IN EENADU PAPER DATED:18-10-2016.
AN APPRECIATION FORM MEDIA & COLLEGE MANAGEMENT:
14
REFERENCES:
Ch.Naga Siva Sai Nadh (Asst. Proff) Civil Dept. Mekapati
Rajamohan Reddy Institute of Technology & Science.
15
16
17