+ All Categories
Home > Documents > Plate Tectonics and the Ocean Floor. Continental Drift Theory proposed by Alfred Wegener in 1912...

Plate Tectonics and the Ocean Floor. Continental Drift Theory proposed by Alfred Wegener in 1912...

Date post: 16-Dec-2015
Category:
Upload: sterling-dannels
View: 219 times
Download: 0 times
Share this document with a friend
Popular Tags:
31
Plate Tectonics and the Ocean Floor
Transcript

Plate Tectonics and

the Ocean Floor

Continental Drift

• Theory proposed by Alfred Wegener in 1912• Continents once formed a single landmass

Early Evidence

Age of Oceanic Crust

Courtesy of www.ngdc.noaa.gov

Paleomagnetism

Plate Tectonics – 1960’s

• Explains HOW the plates moved

The Crust

Continental Crust

- thick (10-70km)- buoyant (less dense than oceanic crust) - mostly old

Oceanic Crust

- thin (~7 km)- dense (sinks under continental crust)- young

Plate Movement

• “Plates” of lithosphere are moved around by the underlying hot mantle convection cells

• Divergent

• Convergent

• Transform

Three types of plate boundary

• Spreading ridges– As plates move apart new material is erupted to fill

the gap

Divergent Boundaries

Mid-Ocean Ridge

• Underwater mountain ranges

• Due to plates pulling away from each other

• A Rift Valley forms in the middle where magma comes out

• Have many fracture zones which break the ridge up

• Black smoker at a mid-ocean ridge hydrothermal vent in the Atlantic.

Close up at the mid-ocean ridge

• Iceland has a divergent plate boundary running through its middle

Iceland: An example of continental rifting

• There are three styles of convergent plate boundaries– Continent-continent collision– Continent-oceanic crust collision– Ocean-ocean collision

Convergent Boundaries

• Forms mountains, e.g. European Alps, Himalayas

Continent-Continent Collision

Himalayas

• Called SUBDUCTION

Continent-Oceanic Crust Collision

TRENCH

• Oceanic lithosphere subducts underneath the continental lithosphere

• Oceanic lithosphere heats and dehydrates as it subsides

• The melt rises forming volcanism

• E.g. The Andes

Subduction

Trenches

• Due to one plate subducting (going below) another plate

• Earthquakes • Many volcanoes and

volcanic island arcs form here

• When two oceanic plates collide, one runs over the other which causes it to sink into the mantle forming a subduction zone.

• The subducting plate is bent downward to form a very deep depression in the ocean floor called a trench.

• The worlds deepest parts of the ocean are found along trenches. – E.g. The Mariana Trench is 11 km deep!

Ocean-Ocean Plate Collision

• Where plates slide past each other

Transform Boundaries

Above: View of the San Andreas transform fault

Volcanism is mostly focused at plate margins

Pacific Ring of Fire

Other Ocean Features

Continental Shelf

• Part of a continent covered by water

• Gentle slope• Average depth is 60

m• Amount exposed

changes with sea level

Continental Slope

• Steep • May be cut by

submarine canyons• Sediment piles up at

the bottom and forms continental rise

Abyssal Plains

• Flattest area on earth• Cover ½ of deep ocean• Covered with fine

sediment

Seamounts

• Submerged volcanic mountains

• Called oceanic island if they rise above water

Guyot

• Seamounts that have been eroded and are now flat on top


Recommended