Laser Marking Systems (LasOnAll XS, Lasonall/Violino 1,2,3 Series Lasers) - 1064nm
Preventive Maintenance Agreement
Service Visit Check List Maximize Uptime
Optimized Marking Quality
Reduced Intervention
Health and Safety - Operator
Clean and Inspect Interior and Exterior Optics ✔ ✔
Clean, Inspect and Change Fume Extraction/ Particle Filtration System Filters
✔ ✔ ✔
Clean and Inspect Air Cooling Systems ✔ ✔
Inspect Any Interface and Linear/Rotary Devices Including Part Handling and Special Features
✔ ✔ ✔
Backup and Update Laser Software/Files ✔
Record and Measure Laser Frequency and Output Power Levels (808nm and 1064nm)
✔ ✔
Record and adjust laser parameters ✔ ✔
Inspect and adjust laser enclosure/safety systems ✔
Perform optical alignment of laser system for maximum power output and transmission
✔ ✔ ✔
Inspect and measure input and output of system ✔
Adjust laser power supplies ✔ ✔
Semi-Annual and Annual PM Agreements ✔ ✔
Laser marking systems in 5W, 10W, 20W, 30W 40W
One supplier for all your marking needs
www.ostling-markingusa.com/[email protected]
✔
✔
✔
✔
✔
✔
✔
and Service and System
✔
✔
Measure and inspect laser connections ✔ ✔
✔ ✔
Full System support including components, repairs and technical assistanceSoftware/Hardware upgrades, design and enhancements for improved system reliabilityReduction in cost of operation and maintenanceReview customer programs to confirm and improve operation
laser maintenance programs that include regular full system evaluations and upkeep including:
optical inspection and optical cleaning and alignmentfactory specified power output verificationlaser stability calibration with laser operation review and calibrationOptical Scan Head inspection/Galvanometer review and motor adjustment/cleaning maintenanceF-Theta lens inspection & cleaning or replacement (mainly protective lens)
640 Lakeview Plaza Blvd Suite C Worthington, OH 43085
Phone: +1 614-231-3559Fax: +1 614-436-4898
USA
✔
✔
✔
✔
✔
✔ ✔
Training and Start-up Assistance (or retraining on older systems or new personnel)
We offer a variety of marking system training options as well beyond our PM:
:On-Site Training at Customer FacilityTraining at your facility after the delivery of your machine. A certified technician will train single or multiple operators or a full day (8 hours) This package is available as an option on all our marking system quotations.
:On-Site Training at Ostling USA FacilityCustomers are welcome at our facility free of charge for training on their machine. After training is complete, your system will ship to your facility for setup. We will trainon full system unpacking, setup, power/air/staging requirements, operation and safety.
:Start-up Assistance with Integration or Machine/System BuildIntegrators, machine builders or end-users integrating our OEM laser products into their production line process, can rely on Ostling for complete marking system support. From the initial application review to the first production mark.Helping with the right marking parameters or helping with onsite mechanical, electrical or control integration with our marking systems.
Refresher or New Employee Training / Safety Training:Review with factory trained technicians on the marking system, including setup,operation, maintenance, application review, part mark optimizing/review, softwarereview/training and Laser/Machine Safety overview/protocol.
One supplier for all your marking needs
Visit us at our website www.ostling-markingusa.com or also at facebook, twitter and youtube
640 Lakeview Plaza Blvd Suite C Worthington, OH 43085
Phone: +1 614-231-3559Fax: +1 614-436-4898
USA