Patented US8469372B2 and Patents Pending

2x Bindings (L and R)

4x Solid-Ride Plates

2x Tour Modes2x Flip-Speed Risers with Heel Lockdown

2x Toe Attachments 2x Heel Attachments

6x M6x10mm Buttonhead ScrewTour Mode

4x for Flip-Speed Riser6x extra for Tour Mode with thin core boards

M6x10mm Flathead Screw8xRide Mode

M6x6mm Buttonhead Screw8xHeel and Toe Attachments

10x M6x8mm Buttonhead Screw

Prime Splitboard SystemAssembly and Use Instructions

Tools:-M4 Allen Wrench (Binding Hardware, Interfaces)-M3 Allen Wrench (Highback Fwd Lean, Heel Lever Size Adjustment)-Cresent Wrench or 11mm socket (Heel Lever Size Adjustment)

Hardware:

Size Chart:Small: 6-8Medium: 8.5-11Large:11.5-13Women's: W6-W8

Scan QR Code for video instructions or visit www.splitboardbindings.com

PAGE 1 OF 5Prime Instructions_A01

M6x10mm Buttonhead ScrewUse M6x8mm Buttonhead for thin core boards

Production Splitboard Installation

1.

2. M6x10mm Flathead Screw8x

.5in .5 in

Center

4x M6x8mm ButtonheadScrew

6x

PAGE 2 OF 5Prime Instructions_A01

M6x6mm Buttonhead Screw8x

10° 20° 30°

Toe Attachment

Heel Attachment

R

3.

Tighten Toe Attachment to 1.desired angle (hash marks in 5° increments)

Leave Heel Attachment loose2.

Mount Binding to align Heel Attachment3.

Tighten screws on Heel Attachment4.

PAGE 3 OF 5Prime Instructions_A01

SMALL POSITION

LARGE POSITION

Only adjust if binding is too tight to mount to Ride Mode or if binding is loose on ride mode.

!

Loosen Toestay screws1.Adjust Toestay fore/aft as desired2.Tighten Toestay screws3.

5. Binding Adjustment

22°10°0°

4. Binding Size AdjustmentSize Setting:S: 6-7M:8.5-9.5L: 11.5W: W6-W7

Size Setting:S: 7-8M:9.5-11L: 12-13W: W7-W8

Forward Lean Adjustment:

Bindings come set at 12° fwd lean

PAGE 4 OF 5Prime Instructions_A01

V

Toe Pins

0° RiseSlide basket under here

Heel Lock

Short12° Rise

Tall20° Rise

Prime Splitboard System Use Instructions

Attach binding to Ride 2.Mode, aligning Toe Pins and Ride Mode Toe Attachment

Close Heel Lever and Safety3.

Ride Mode:Open Heelcup Lever1.

Flip-Speed Riser:Operation:

Slide basket of ski pole under tall riser to flip up1.Flip riser to short position or long position with tip of ski pole2.Lower riser by pushing on tall riser towards tail of ski3.

Heel Lock Operation:Tour with Heelcup Lever open 1.Close Heelcup Lever to 2.engage pins with Heel Lock

PAGE 5 OF 5Prime Instructions_A01