19
Open Arduino_GPS.PrjPCBIt is included in the same PDF folder
2.
1.
2. Open the PCB File
3.
To include the OutJOB file in your
PCB projecy you must load the file.
1.
2.
3.
4.
Go to Fabrication Outputs and
Configure the NC drill and Gerber
1.
Select the PCB version you want to export
Configure the export options (Use RMButtom)
2.3.
In the Gerber Setup options
1.
Select ALL Layers
Always use RS274X in your Gerber files
1.
Select Embedded apertures
Go over the advanced options
1.
It is important to know what options has been selected. Other valuesare also possible.
Let’s configure the NC Drill File
1.
It is important to know what options has been selected. Other valuesare also possible.
2. Use RMB
Open the NC Drill Setup Options
1.
In 1. use the higher
resolution available.2.
In 2. you can select any
option.
If you are going to use CIRCUITCAM you have to
remember the chioces you set in these Radio buttoms.
3.
Let’s assign the PATH where these files are
going to be saved.
1.
Let’s assign the PATH where these files are
going to be saved.
1.
Clik the Advanced Buttom
Let’s assign the PATH where these files are
going to be saved.
1.
If you use LMB on GERBER(1.) you can change the PATH
Create a new folder in you PCB Project folderfor all the outputJob you generate.
Now it’s time to Generate the files.
1.
Click on the Generate content arrow.
Follow this procedure with all your OutJob task.
Remember...............
Use this procedure to generate:
1. 3D Videos
2. Print your PDF (SCH and PCB)
3. Export SCH Netlist for outter simulation
4. NC Drils
5. Gerber Files
6. Pick and Place files
7. 3D Prints (Top & Buttom)
8. Final Artworks print
Follow this procedure with all your OutJob task.
You can generate Reports, Validation and
Export outputs in a simple way.
Follow this procedure with all your OutJob task.
1.
2.
3.
4.
Once you have run all
the OutJob, the
CamTastic file has been
created..
You will access to this window.
1.
2.
You can start the Panalization processTools Panelize PCB
1.
2.
Select the PCB you want to panelize.
Introduce the panels sizeUse RMB
1.
2.
Panel Size and spacing data
Panelization results
1.
TH
AT
’s ALL F
OLK
S !
