Art. 659, 1200 g/m2
Art. 659 1PF (weldable PVDF)
ATTENTION: Colours may differ from the original due to printing reasons
PRO-TEX ARCHITECTURE
Lacquer options:
PVDF weldable
PVDF non-weldable
TiO2 primer & PVDF lacquer
PVDF
Polyester fabric, both sides PVC-coated and lacquered, high-gloss embossed, REACH compliant.
Technical data shown below are
average values of the current
productionStandards 659 1PF
base DIN 60001 Polyester
yarn DIN EN ISO 2060 1670 dtex
weave DIN ISO 9354 Panama 2:2
total weight DIN EN ISO 2286-2 1200 g/m2
thickness - 0,99±0,01mm
max. tensile strength DIN EN ISO 1421 5600 / 5400 (N/5 cm)
tear strength DIN 53363 1000 / 900 (N)
adhesion DIN EN ISO 2411 100 (N/5 cm)
cold resistance DIN EN 1876-1 -30
heat resistance IVK/Pkt.5 +70
colour fastness DIN EN ISO 105-B02 min. 7
flame retardancy
(Always check the validity of fire certificate.)
EN 13501-1
resistance to damage by flexing DIN 53359-Form A No cracks after 100.000 flexures
light transmission DIN EN 410 4,05 %
radiation transmission DIN EN 410 5,17 %
radiation reflection DIN EN 410 81,37 %
radiation absorption DIN EN 410 13,46 %
g-value DIN EN 410 0,0865
solar reflectance index (SRI) 106
application temporary and permanent structures
POLYFAB MIDDLE EAST LLC
PO Box 450008 – Dubai
UNITED ARAB EMIRATES
Tel +971 4 884 7933
Fax +971 4 884 7934
www.polyfab.com.au
Note: Subject to change depending on technical upgrades. Values indicated without their specific tolerance levels are nominal values with a tolerance of ±10 %. All data presented is given to the best of our current knowledge for guidance purposes and is not legally binding. Sattler AG must give their written consent to uses other than specified. No liability will be granted without the prior written consent of Sattler AG for usages other than herein specified. The technical data in the material data sheet is based on experience from current productions and does not constitute any quality agreement. This data refers to goods in ex-works condition without any processing or handling by the customer. The given data is informative only and merely serves as a guide. It will in no way release the customer from checking the suitability of the intended use or of any resulting liability, before processing and/or treatment.
Disclaimer: Sattler PRO-TEX GmbH sells membranes based on the specifications as detailed in the technical data sheet valid at the time. Current tech-nical data sheets are available on request. Sattler PRO-TEX GmbH is not responsible for the suitability of the membranes for any specific application. It is the responsibility of the fabricator/engineer to test and to approve the suitability of the membrane for the intended application.
Sattler PRO-TEX GmbH
Sattlerstrasse 45
A-8077 Gössendorf
Tel +43 316 4104-560
Fax +43 316 4104-360560
www.sattler-protex.com
Material Approval:
TECHNICAL SPECIFICATIONS
Ver
sion
2 /
06
20
17
