1
Programming instructions for signal transmitter The signal transmitter for extractor art.no.: 9060 can be set to an alternative program designed especially for extractors type Renferts Silent TS. This program ensures the correct function of the automatic mode in connection with the Schick micromotors. To activate the alternative program, the signal transmitter has to be connected to a power supply. Afterwards: 1) Press button (1) by a sharp instrument for at least 5 seconds, the LED inside the housing flashes shortly, turns off, turns on and stays on. Program 1 is active. The LED is visible only through the ventilation holes as shown in pic.2! 2) Press button (1) again shortly, LED turns off two times and turns on two times. The alternative program 2 for Renfert extractors is now active. 3) Wait for about 30 seconds until the LED turns off. The signal transmitter is now ready for use. button (1) 11/18 gz D21467 viewing direction to the LED inside the housing pic.1 pic.2 To switch the signal transmitter back to program 1, repeat step 1. This manual is available as a video tutorial here: https://www.schick-dental.de/en/service-reparatur/reparaturanleitungen1/signalgeber Link to the video manual
