PowerPoint Presentation

Question 1In which quadrant would the point (3,-4) be located?

Question 2The coordinate for point P (3, 9) is shown below. What would be the new coordinate for point P, if the point was translated 3 units to the right and 7 units down?

Question 3Draw a sketch of the top, front and left view of the solid below.

Question 4Line segment MN has endpoints at (-3, -2) and (5, -2) respectively. The middle of the line segment is at which point?

Question 5 The top, front and side view of a figure are shown below.What three-dimensional figure can be made given these views?

Question 6Use the coordinate plane below to completeParts A, B and C.Plot points A (-6,3), B (-6,-4) and C (2,-4) on the coordinate grid. B. What is the coordinate for D, the fourth point, that would create a rectangle?C. Plot point D and connect the points to create the rectangle.

Question 7The coordinate plane shows the translation of figure A to figure B.How are the coordinates of Figure B related to the coordinates of Figure A?

Question 8 RQM is a translation of ABC Which of the following describes the translationF. 5 units left and 5 units upG. 5 units left and 5 units downH. 5 units right and 5 units upI. 5 units right and 5 units down

Question 9A particular solid shape has these views.In the space below, draw the solid that represents these views.

What is the name of the solid you drew in part A?

Question 10The figure below was transformed from Quadrant I to Quadrant IV.This transformation represents a __________ . Fill in the blank.

F. reflectionG. rotationH. translationJ. tessellation