Quick flux calculation for real time feedback
Injector holepattern
Intersectionof jets onplaten
Injector design
“jets.txt” files canbe imported
Various ways oftransforming data
Tabs select various functions
Jet number gets enteredautomatically by programas you enter the other data.
Parameters for calculation
Results of 2 dimensional calculationPlaten can be non-rotated, rotated, or partially rotated
Diameter plot for rotating platen
Tweak up and down
Checks for intersection of holes
Input hole diameter, plate thickness, andthe minimum acceptable clearance
To change axes on plots: Highlight value andtype in new value.
These controls autoscale the axes.
The lock toggles between autoscaleand fixed scale
There are also zoom controls
Right clicking on table pops-upa menu for manipulating data
Scale. Useful for adding smallIncrements of angle on selected jets.
Create series. Useful for creating ringsof holes or for spirals.
Multi-series. Alternates between 2 or 3different values. Green button selects2 or 3 values.
Randomize order of values in a selection
You get one “undo” for any of these transformations
All of these controls work on the data thatIs selected in the table
Blue curve is a reference you can saveto see if changes are helping or hurting.
Changes injector design back to stored design
Stores current designHide reference
When you first start the program you need tocalculate the flux curve otherwise it is all zeros.(even though the graph shows a curve to start)
Cartesian and polar plots of the fluxdistribution from each hole.
Data can be read in from external files.Data should be relative flux vs. angle in degrees.
2 different models are included in program.
Efficiency calculation calculates fraction of interceptedflux vs. platen radius.