+ All Categories
Home > Documents > Quick Guide to Install Cryptocam 1.0.0

Quick Guide to Install Cryptocam 1.0.0

Date post: 09-Jan-2016
Category:
Upload: aaaaaa
View: 228 times
Download: 0 times
Share this document with a friend

of 10

Transcript
  • I PCT-05-01

    5F., Seungwon B/D, 810-9 Bangbae-Dong, Seocho-Gu, Seoul, 137-064, Korea

    Tel : +82-2-596-1331 Fax : +82-2-596-3707 E-mail : [email protected] http:// www.cryptotelecom.com/

    A Quick Guide to Install CryptoCam or CryptoServer (Applied to I-400, I-500. I-510, S-121, S-131 and S-152)

    1. Install Client Viewer Software on Your PC Install MPEG4 A/V Communicator on your PC The software is on a installation CD packaged with CryptoCam (or CryptoServer) or can be

    downloaded on CryptoTelecoms web site;

    http://www.cryptotelecom.com/2004ct/english/support/recorder.htm

    The software is installed at C:\Program Files\CryptoTelecom\MPEG4 Communicator

    [Figure 1-1]

    2. Check Your Local Network Setting Run Prompt Window Type ipconfig

  • II PCT-05-01

    5F., Seungwon B/D, 810-9 Bangbae-Dong, Seocho-Gu, Seoul, 137-064, Korea

    Tel : +82-2-596-1331 Fax : +82-2-596-3707 E-mail : [email protected] http:// www.cryptotelecom.com/

    [Figure 2-1]

    IP address of CryptoCam (or CryptoServer) is set to 192.168.1.8. Users should change the IP address if it is not according to the default gateway of your network.

    3. Connect CryptoCam (or CryptoServer) to Your PC with LAN Cross Cable

    [Figure 3-1]

    CROSS LAN CABLE

  • III PCT-05-01

    5F., Seungwon B/D, 810-9 Bangbae-Dong, Seocho-Gu, Seoul, 137-064, Korea

    Tel : +82-2-596-1331 Fax : +82-2-596-3707 E-mail : [email protected] http:// www.cryptotelecom.com/

    4. Change the IP Address of CryptoCam (or CryptoServer) Using IP Utility Run IP Utility

    [Figure 4-1]

    Click IP Find button to scan CryptoCam (or CryptoServer) installed on your network Then, the network values of CryptoCam (or CryptoServer) are shown on the table. Double click the

    scanned IP address.

    Enter a new IP address of CryptoCam according to your local network setting. (e.g. if IP address of your PC 192.168.0.11, then IP of CryptoCam must be 192.168.0.X which is not pre-assigned.)

    Enter Default Gateway as shown on the figure 2-1. Enter SubNet Mask as shown on the figure 2-2. Enter password. Default password is admin. Click IP Change Button

  • IV PCT-05-01

    5F., Seungwon B/D, 810-9 Bangbae-Dong, Seocho-Gu, Seoul, 137-064, Korea

    Tel : +82-2-596-1331 Fax : +82-2-596-3707 E-mail : [email protected] http:// www.cryptotelecom.com/

    [Figure 4-2]

    New IP address has been assigned.

    5. View Live Images from CryptoCam Using Web Browser

    [Figure 5-1]

  • V PCT-05-01

    5F., Seungwon B/D, 810-9 Bangbae-Dong, Seocho-Gu, Seoul, 137-064, Korea

    Tel : +82-2-596-1331 Fax : +82-2-596-3707 E-mail : [email protected] http:// www.cryptotelecom.com/

    Enter IP address of CryptoCam on URL of Internet Explorer. Click Administrators Page to set up configurations. (to be reviewed later) Click Connect to see live images on web viewer.

    [Figure 5-2]

    [Figure 5-3]

    Enter ID & PW as shown on the figure 5-2. Default values are root & root. Click the lock icon to view live images

  • VI PCT-05-01

    5F., Seungwon B/D, 810-9 Bangbae-Dong, Seocho-Gu, Seoul, 137-064, Korea

    Tel : +82-2-596-1331 Fax : +82-2-596-3707 E-mail : [email protected] http:// www.cryptotelecom.com/

    Then, live images can be viewed on web viewer.

    [Figure 5-4]

    6. Connect CryptoCam Directly to the Internet Line (Router, IP-shared Device) If you follow the steps above and see the live images, it means that CryptoCam are ready to work on local connection (LAN). In order to make CryptoCam accessible from the Internet, you should assign

    ports to CryptoCam and make port forwarding on administrator page of your router.

    [Figure 6-1]

    Straight LAN CABLE

  • VII PCT-05-01

    5F., Seungwon B/D, 810-9 Bangbae-Dong, Seocho-Gu, Seoul, 137-064, Korea

    Tel : +82-2-596-1331 Fax : +82-2-596-3707 E-mail : [email protected] http:// www.cryptotelecom.com/

    Remove cross LAN cable between PC and CryptoCam Connecting CryptoCam directly to your router(or IP-shared device) as shown on figure 6-1.

    7. Make CryptoCam Accessible from the Internet 7-1 Network Setting on Administrators Page

    Click Administrators Page button to access Administrators Page of CryptoCam. (Refer to 5-2)

    [Figure 7-1]

    Log in Administrator Page. Default ID & Password is admin & admin

    [Figure 7-2]

  • VIII PCT-05-01

    5F., Seungwon B/D, 810-9 Bangbae-Dong, Seocho-Gu, Seoul, 137-064, Korea

    Tel : +82-2-596-1331 Fax : +82-2-596-3707 E-mail : [email protected] http:// www.cryptotelecom.com/

    Go to network setting menu.

    [Figure 7-3]

    Check DNS Server .

    [Figure 7-4]

    One of the two values should be 211.176.62.86 which is the address of CryptoTelecoms central operation server named PIMA(Refer to each manual or CryptoTelecoms web site for more detailed information). One

    is according to your ISPs DNS server.

    Assign ports to CryptoCam

    [Figure 7-5]

    The number of port differs according to CryptoTelecoms product models. In case more than 2 CryptoCams are installed on the same network segment. You should check User Port radio button and assign new ports to CryptoCam.

  • IX PCT-05-01

    5F., Seungwon B/D, 810-9 Bangbae-Dong, Seocho-Gu, Seoul, 137-064, Korea

    Tel : +82-2-596-1331 Fax : +82-2-596-3707 E-mail : [email protected] http:// www.cryptotelecom.com/

    Each port must not be shared. Popular applications might use the ports below 1000 so that you are recommended to assign ports over 1000.

    7-2 Port Forwarding on your own routers Setup Page How to make port forwarding differs according to kinds of router. From more detailed information, please consult your network manager or refer to router manual.

    Go to port forwarding menu on your routers setup page. Open the assigned ports (e.g. 9000, 9001 for I-400, web port 80 is a basic port always open) on the

    IP address of CryptoCam

    [Figure 7-6]

    e.g. port numbers 4000 to 4004 has been opened on 192.168.0.153 for both TCP and UDP protocol..

  • X PCT-05-01

    5F., Seungwon B/D, 810-9 Bangbae-Dong, Seocho-Gu, Seoul, 137-064, Korea

    Tel : +82-2-596-1331 Fax : +82-2-596-3707 E-mail : [email protected] http:// www.cryptotelecom.com/

    8. Epilogue For more detailed information, please refer to each manual which can be downloaded on our

    website; http://www.cryptotelecom.com/2004ct/english/support/camera.htm

    If live images cannot be viewed, please follow the procedure from chapter 1 to 5 and see if it can be viewed on cross LAN cable connection.

    Please contact CryptoTelecom for your further inquiry or request. Overseas sales manager: B.G.. Park (Mr)

    TEL: +82-2-596-1331 (ext. 242) FAX: +82-2-596-3707 E-mail: [email protected]

    Thank You for Purchasing CryptoTelecom Products!


Recommended