+ All Categories
Home > Education > Rain water harvesting

Rain water harvesting

Date post: 19-Jan-2015
Category:
Upload: nitin-chhaperwal
View: 827 times
Download: 0 times
Share this document with a friend
Description:
Every drop of water is precious.
Popular Tags:
19
Rooftop Rainwater Harvestin g Pre- implementatio n N itin C hhaperw al C lass :-ix R ollN o.:-915 P repared B y ;-
Transcript
Page 1: Rain water harvesting

Rooftop Rainwater Harvesting

Pre-implementation

guide for schools

Nitin ChhaperwalC lass :- ix

Roll No. :- 915

Prepared By ;-

Page 2: Rain water harvesting

Why?

At the city level

• Reduces water demand • Reduces energy demand – lesser energy required for water distribution • Improves groundwater situation • In coastal areas, it can counter saline water intrusion into freshwater aquifers • Prevents urban flooding

Page 3: Rain water harvesting

Why?At the school level • Reduces water bills • Sets an example for students and parents • Improves groundwater table if rainwater is recharged • Improves groundwater quality by dilution (rainwater has nearly neutral pH and zero hardness)

Page 4: Rain water harvesting

How?

Recharge if there’s excess

The concept is simple

Collect

Store

Use

Page 5: Rain water harvesting

ROOFTOP RAINWATER HARVESTING

Catchment – rooftop

Transportation – Down take pipes

Filters – First flush device

Leaf and grit filter

Storage – Tank / well

Components

Page 6: Rain water harvesting

How much water can we harvest?

Rain Water Collected From Both Sides of the Roof

W

Rain Water Collected From one Side of the Roof

Amount of rainfall(mm)

x =

W

Catchment Area(m2)

Volume of water received(Litres)

Page 7: Rain water harvesting

The water that leaves the rooftop may be 65 – 90% of the water that falls on it

Roof material absorbs some water

More water loss if roof is flat

Evaporation losses

Page 8: Rain water harvesting

Keep the roof clean

• Remove leaves, plant debris, bird and animal droppings, dead rodents or birds

• No tar / bitumen on the roof

• No chemical pesticides or fertilizers for rooftop garden

Page 9: Rain water harvesting

Transportation

Pipe size is calculated based on peak flow rates (rooftop area and peak rainfall rate)

Gutter (open on top)

Downtake pipe (cylindrical)

PVC pipes preferred. Do not use lead pipes

Page 10: Rain water harvesting

Take care….

• Clamp gutters and down take pipes well

• Keep gutters clean of leaves

• See that leaves do not clog a down take pipe (Jaali or leaf filter may be needed at rooftop discharge point

but this may also be a problem if leaf debris collects on it and water stagnates on the roof)

• Gutters and down take pipes should be gently sloping towards the storage tank, so that there is no stagnation of water in the pipe

Page 11: Rain water harvesting

Filters

http://www.rainyfilters.com/rainwater.aspx

Gravel

Sand

Inlet

Out flow

Over flow

Gravel

Recharge tank

Filter

Storage tank

Down take pipes

First flush

Check and clean filters before and after each rainy season

Make your own filter with sand, charcoal and gravel

Or

Buy a filter off the shelf

Page 12: Rain water harvesting

First flush

• The first rain carries with it a lot of filth from the rooftop and dissolved air pollutants

• This rainwater should be diverted away from the storage tank using a first flush device.

• Some filters have a first flush system integrated in them

• Check and clean first flush devices regularly.

First flush standpipe

Page 13: Rain water harvesting

STORAGE SIZE

Depends on

• Rainwater availability

• Water requirement

• Budget (storage tank is most expensive part of (rwh system)

• Available space and aesthetics

Excess water can be diverted into a groundwater recharge system

Do a water audit to check water requirement.

Page 14: Rain water harvesting

STORAGE• Above ground

– Ground level or Intermediate floor level

– Just below roof

• Below ground Save on pumping cost

Page 15: Rain water harvesting

Storage tank features

• Durable and no leaks

• Built on a strong and stable substrate that can support the tank filled with water

• Opaque – presence of light can cause algal growth in tank

• Secure and impervious cover

• Vents to be covered with insect proof mesh

• Located as close as possible to demand and supply points to reduce plumbing

Page 16: Rain water harvesting

• Overflow pipe should be provided close to the top, to reduce dead space.

• Overflow pipe diameter should be equal to inlet pipe diameter

• Overflow pipe should lead excess water away from the foundation of tank and other buildings. Preferably the overflow should be led into a groundwater recharge system or a garden

• There will be sedimentation in the tank. Taps and pipes to draw water from the tank should not be very close to the bottom to prevent sediments from entering the plumbing system and clogging it.

Storage tank features

Page 17: Rain water harvesting

What can we use the rain water for?

If used for drinking, it is absolutely necessary to check water quality in a lab and treat as required

Page 18: Rain water harvesting

Other factors

• Some changes may be required in plumbing, if retrofit

• Clean rwh system regularly – Rooftop everyday– Tank after a rainy season– Filter after a rainy season

Page 19: Rain water harvesting

Rainwater Harvesting

DO IT NOW!


Recommended