This document, including images, may not be reproduced partly or fully without the expressed written consent of National Products, Inc. To see more mounting options, visit rammount.com While holding (H) nuts in place, attach ball adapter to back of holder using (G) screws. RAM ® logo must be facing in the shown direction. Attach additional (L) screws. Twist key lock to release internal slide. Position (H) nuts in nut pockets, guiding them in place with a pen. *Note: End cups may vary Parts index 2 3 5 Using (K) screws, attach one end cup to Tab-Lock. 4 Using (K) screws, attach one end cup to the top slide with numbers facing down. M Insert top slide over internal vehicle dock. 6 1 * * K J G L 4x 10x 2x 2x 2x 2x 2x 2x 2x H N *Note: Ball adapter sold separately 7 Place (N) nuts into top slide, aligning with holes in internal slide. This document, including images, may not be reproduced partly or fully without the expressed written consent of National Products, Inc. To see more mounting options, visit rammount.com RMR-INS-TL TAB-LOCK™ Phone: 1.800.497.7479 www.rammount.com [email protected]Tab-Lock ™
Transcript
This document, including images, may not be reproduced partly or fully without the expressed written consent of National Products, Inc.To see more mounting options, visit rammount.com
While holding (H) nuts in place, attach ball adapter to back of holder using (G) screws. RAM® logo must be facing in the shown direction. Attach additional (L) screws.
Twist key lock to release internal slide.
Position (H) nuts in nut pockets, guiding them in place with a pen.
*Note: End cups may vary
Parts index
2
3
5
Using (K) screws, attach one end cup to Tab-Lock. 4 Using (K) screws, attach one end cup to the top slide with numbers facing down.
M
Insert top slide over internal vehicle dock.6
1
*
*
KJ GL4x 10x 2x 2x 2x 2x 2x
2x2x
H N
*Note: Ball adapter sold separately
7 Place (N) nuts into top slide, aligning with holes in internal slide.
This document, including images, may not be reproduced partly or fully without the expressed written consent of National Products, Inc.To see more mounting options, visit rammount.com
This document, including images, may not be reproduced partly or fully without the expressed written consent of National Products, Inc.To see more mounting options, visit rammount.com
Turn Tab-Lock over. Secure front cover using (J) screws on back of slide assembly. Lock must be engaged to access all four holes as shown.
Position front cover over vehicle dock assembly.
10
15 16
Release lock and remove tablet. Set your top cup to the appropriate setting using the reference number from step 13. When in place, fully tighten the (M) screws.
14
11 12
98
This document, including images, may not be reproduced partly or fully without the expressed written consent of National Products, Inc.To see more mounting options, visit rammount.com
RMR-INS-TL
13 On the back of the top slide, review the numbers shown in the middle. Take note of the lowest number that is fully visible. This reference will help you in the next step. In this example, the lowest visible number is 8.
Place tablet on bottom docking cup. Press down on top cup to secure over tablet.
Attach (M) screws from behind the internal slide. Do not fully tighten (slides must remain loose).
With the numbers facing down, wedge top slide cover into top slide. Using pressure, snap into place.
