RCDC Database (PostgreSQL)

Installation walkthrough

Step 1: Language selectionSelect English as the default language and click Start

Step 2: Introduction screenIntroduction message. Click Next to get started.

Step 3: Welcome message and instructionsRead the complete instructions before you continue and click Next

Step 4: Feature selectionKeep default selection and click Next

Step 5: Service installationCheck Install as Service . Keep all settings as default only enter password and click NextAccount Password : admin@123456789Verify Password : admin@123456789

Note: This will prompt you to inform that a new user will be created click on yes

Step 6: Initialise DatabaseKeep all the settings as default only enter the password and click NextPassword : adminPassword(again) : admin

Step 7: Procedural languagesSelect PL/pgsql and click Next

Step 8: Contrib modulesSelect admin pack and plDebugger and click Next

Step 9: Ready to installClick Next to start the actual installation.

Step 10: InstallingA progress bar is shown during the installation.On some versions of Windows (notably Windows XP before Service Pack 2 and Windows 2003 before Service Pack) a command prompt window will appear during the "Initializing database cluster" step. Don't close this window - it will automatically close once the operation is complete.

Step 11: FinishedUncheck Launch Stack Builder and click FinishInstallation is complete.