11
12/07-2006 Lars Søby CTF3-CLEX meeting 1 Review of existing CTF3 BPM’s and related data acquisition
12/07-2006 Lars Søby CTF3-CLEX meeting 1
Review of existing CTF3 BPM’s and related data
acquisition
12/07-2006 Lars Søby CTF3-CLEX meeting 2
BPE
Electrostatic PU.Ceramic tube containing 4 electrodes. 4 feed-thru2 units in Linac High impedance buffer followed by standard acquisition system
12/07-2006 Lars Søby CTF3-CLEX meeting 3
BPI
WCM type PU using current transformers.Racetrack vacuum chamber.4 electrodes, no feed-thru.Delay loop + Linac 19 units. No analogue electronics.CR +TL1 27 units is foreseen. Standard acquisition system.TL2 ??
12/07-2006 Lars Søby CTF3-CLEX meeting 4
BPM
WCM type PU using current transformers.Circular vacuum chamber.8 electrodes, no feed-thru.23 units in the Linac.CR +TL1 6 units is foreseen. TL2 ??Standard acquisition system.
12/07-2006 Lars Søby CTF3-CLEX meeting 5
BPR
Button PU and wave guide port.Circular vacuum chamber.4 buttons with feed-thru.2 units in the Linac, 1 in the CT line.CR 1 unit is foreseen. TL2 ??Down mixing using 3GHz referenceWave guide detector.Standard acquisition system.
12/07-2006 Lars Søby CTF3-CLEX meeting 6
WCM
7GHz WCM. Circular vacuum chamber.2 mm air gap. 8 feed thrus3 units in the Linac.1 unit at exit of delay loop. 1 is foreseen for TL2 Standard acquisition system for low frequencies.
12/07-2006 Lars Søby CTF3-CLEX meeting 7
Layout of BPM acquisition system
Tunnel Equipment Room
12/07-2006 Lars Søby CTF3-CLEX meeting 8
Front-end electronics
12/07-2006 Lars Søby CTF3-CLEX meeting 9
Layout of BPM acquisition system
Tunnel Equipment Room
12/07-2006 Lars Søby CTF3-CLEX meeting 10
Acquisition Hardware
SIS 3300/20 VME module
8 channels @ 100/200 MHz12 Bits (-2.5 2.5 V)Ext triggerExt 96/192 MHz clock
12/07-2006 Lars Søby CTF3-CLEX meeting 11
Thank you for your attention
