PRINTED SIZE VALIDATION BOX

Measure the above bar with a ruler. If it is not accurate the ring size measurement will

notbe correct.

MEASURING AN EXISTING RING

1. Print the guide

2. Use a ruler to confirm the printed paper size in the "printed size validation box"

3. Choose a ring that correctly fits the finger you are purchasing the ring for

4. Find the circle from below that closely match the inside edge of the ring

5. If the ring falls between two of the sizes, order the quarter size in the middle

IMPORTANT NOTES!

First use a ruler to confirm the printed paper size in the "printed size validation box".

The size measurer must fit snugly to be accurate so pull it tightly.

Measure your finger at the end of the day (when it is at its largest)

Don't measure your fingers when they are cold or damp (theywill be at their smallest).

Rings over 5mm in width may fit your finger more tightly than rings in narrower widths.