1. Connect to Ethernet

Connect Ethernet cable to receiver.

Enter Menu/Internet/network Local Setting, see did receiver obtained IP address correctly, if it is ok, you will

see your IP address in this window after couple seconds. If not, switch DHCP to OFF and set IP manually.

2. Connecting to the server Go to MENU/Internet/Net client config

You can choose server here, there can be maximum 8 servers.

Press YELLOW button to EDIT server.

Edit each field replacing the text with your server settings.

If server which you connect to is NEWCAMD, you should get from your donor:

1. Server name (or IP of the server)

2. Service port

3. User name

4. Password

5. DES key

6. Press ACTIVE SERVER (dot from left side will change color from white to green)

7. Press STORE to save settings

If you have access to CCCAMD server, you have to input:

1. Server name (or IP of the server)

2. Service port

3. User name

4. Password

5. Press ACTIVE SERVER (dot from left side will change color from white to green)

6. Make sure you changed protocol to CCCAMD

7. Press STORE to save settings

After Exit receiver will automatically try to connect to the server, if all ok, will color of the server will change to

green:

3. Read-in server from text file. Available from sw version 1.1.34 or newer.

Put file directly on USB, without any folder.

File with server can be read-in only from menu “net client config” by “FIND” button on remote( see above)

Content of the file:

# hsdata.cfg - config file for X403p X402p working from software 1.1.29

# need copy this file to C: of ur usb stick. then put receiver to read

# cmd -> cfg~lock~hide~pass

# sample cfg~1~1~00110022 means , u will lock the server info menu. also hide the server info. the password to watch is 00110022

# cmd -> protocol~host~port~user~pass~des

# sample newcamd~192.168.2.3~10000~dummy~dummy~0102030405060708091011121314

# sample homecamd~192.168.2.3~10000

# sample homecamd2~192.168.2.3~10000

# sample cccamd~192.168.2.3~10000~dummy~dummy

# sample nasscamd~192.168.2.3~10000

#newcamd~192.168.2.3~11000~dummy~dummy~0102030405060708091011121314

#newcamd~192.168.2.3~12000~dummy~dummy~0102030405060708091011121314

#homecamd~192.168.2.3~13000

#homecamd2~192.168.2.3~14000

#cccamd~192.168.2.3~15000~dummy~dummy

#nasscamd~192.168.2.3~16000

#nasscamd~192.168.2.3~17000

So first we edit file on PC and input our server settings,

For newcamd it will look like::

newcamd~server~port~username~password~DESkey

for cccamd:

cccamd~server~port~username~password

without any space and “#” sign (text with “#” on front is skipped)

read-in the file from Net client config menu by FIND button:

1. Press FIND on remote

2. Press YES on the screen to confirm

3. Wait until receiver will reboot