Home > Technology > S 7000 Eyelet Pin Inserter

S 7000 Eyelet Pin Inserter

Date post: 14-Jul-2015
Category:
Author: guo-angela
View: 92 times
Download: 4 times
Share this document with a friend
Embed Size (px)
Popular Tags:
of 12 /12
www.smthelp.com Email: [email protected] HP:+86-139 23898396 Tel: +86-755-83203237 Fax:+86-755-23240492 Skype ID: angela7140 Prepare by: Angela Guo Eyelet Pin Insert Eyelet Pin Insert S-7000 S-7000
Transcript
  • www.smthelp.comEmail: [email protected]:+86-139 23898396Tel: +86-755-83203237Fax:+86-755-23240492Skype ID: angela7140Prepare by: Angela GuoEyelet Pin Insert S-7000

  • Eyelet Pin Insert S-7000 Specification Parameter

  • -S-7000 DescriptionEyelet/Pin S-7000 - In DetailPart one: Feeder station

    1. Vibrating feeder sequence bulk rivet/Eyelet pin to length rail.2. Use Eyelet/Pin's weight through length rail slide down to feeder slider.3. Feeder Cylinder drive the feeding slider to push the eyelet/pin on arc rail one by one. 4. Pressure air put eyelet/pin through arc rail and push it to the material Clip of insertion Head.

  • -S-7000E DescriptionEyelet/Pin S-7000E - In DetailPart Two: Insertion Part1. Head Cylinder drive the insertion rod and under pressure, guide pin through eyelet/pin pisitioning.2. Conical part of slide nozzle will push rocker arm with material clamping to opening to both sides, Slide nozzle will press Eyelet/pin to the through hole of PCB.

  • Eyelet/Pin S-7000E - In Detail-S-7000E DescriptionPart Three: Base PartThe base cylinder to drive the base axis to up move, lower die insert to eyelet/pin bottom, the blade of lower die cutting the eyelet/pin bottom and pressing to blossom process.

  • Eyelet/Pin S-7000E - In Detail-S-7000E DescriptionPart Four: Loader CoveyorThe Loader transport the PCB to loader conveyor.

  • Eyelet/Pin S-7000E - In Detail-S-7000E DescriptionPart Five: X-Y working Part1. The Loader conveyor transport the PCB to X-Y work table, X-Y servo motor to drive the X-Y work table positioning.2. After base part of Insertion Head finish the insertion (Detection system will inspect the insertion successfully into the next step, if not finish then repeat this action), X-Y work table will transport the completed insertion PCB to Unloader conveyor.

  • Eyelet/Pin S-7000E - In Detail-S-7000E DescriptionPart Six: Unloader Conveyor1. The Unloader conveyor will transport the completed insertion PCB to Unloader.

  • Eyelet/Pin Insertion PCB

  • Eyelet/Pin Insertion PCBEyelet/Pin Eyelet/Pin after insert to PCB

  • Odd Form Inserter S-7000 S-7000 Videohttps://www.youtube.com/watch?v=6lSC3Gbn4ws

  • Our customers


Recommended