1
Adhesive Info Sheet 1 S150 Aerosol Spray Adhesive is a water-based aerosol adhesive recommended for use with vinyl sheet, plank and tiles, vinyl composition tile, carpet cushion, cove base or carpet tiles over porous and non-porous substrates. Shaw S150 demonstrates highly aggressive grab and shear strength, and has outstanding water and plasticizer resistance. The simple spray application eliminates trowels and rollers. • Non-flammable • Simple spray application eliminates trowels and rollers • Very low odor • No solvents or hazardous chemicals • “Zero” (calculated) VOC • Outstanding water resistance when dry • Passes Air Quality Standards per California Section 01350 • CRI Green Label Plus approved • When used with Patcraft resilient products, installation carries an exclusive 10 year underbed warranty See technical data sheet for environmental, LEED and expanded usage information • NON-FLAMMABLE, No Solvents • Very Low Odor, Zero (calculated) VOC Content Shake well before using. Contents under pressure. Use on porous or non-porous surfaces, such as properly prepared metal, wood, fiberglass, Terrazzo, existing vinyl composition tile, and concrete substrates with up to 90% in-situ Relative Humidity as determined per latest version of ASTM F2170, and pH up to 10.0. Do not use on substrates that have been chemically cleaned. Coverage: Coverage will depend on use, approximately 150 square feet per can. Clean up: Clean wet adhesive from overspray and drips, and on spray tips between uses with soap and water and a clean cloth. Dried adhesive may require the use of a solvent adhesive cleaner. Shelf life: 1 year from the date of manufacturing, in an unused container. Protect from Freezing. Warning: • Do Not Puncture or Incinerate – Dispose empty containers per local requirements • Keep Out of Reach of Children • Do Not Expose to Temperatures Exceeding 115° F (46° C) • Prolonged Exposure to Heat or Sun May Cause Container to Burst • Do Not Allow Product to Freeze First aid: Avoid contact with eyes and skin. For eye contact, flush thoroughly with water for 15 minutes and get immediate medical attention. For skin contact, wash area with soap and water. If swallowed, do not induce vomiting; get medical attention immediately. If inhaled, remove person to fresh air; for difficulty breathing, get immediate medical attention. To obtain the current MSDS and Technical Data Sheet, please visit www.patcraft.com Patent Numbers 5,931,354 & 6,075,078
