+ All Categories

[email protected] [email protected] 3651 Pegasus Dr ...

Date post: 10-Jan-2022
Category:
Upload: others
View: 8 times
Download: 0 times
Share this document with a friend
2
Lateral View Rear View Front View PROTON-16AI Wireless Smart RTU Specifica�on and design are subject to change without no�fica�on All product names referenced herein are registered trademarks of their respec�ve companies CPU ARM9 400MHz on Atmel AT91SAM9G25 Flash Memory 256 MB Nand Flash SDRAM 28MB / 256 MB DDR2 Serial Port Baud Rate: 300bps –921.6 Kbps Parity Check: None, Odd, Even Data Bits: 5,6,7,8 Stop Bits: 1, 2 Connector: 3 Terminal Block Connector Protecon: 15KV ESD Isolaon: Magnec. Ethernet 10/100/1000M Auto negoaon Protecon: Built-in 1.5kV magnec isolaon 900 MHz Radio Modulaon Frequency 902 to 928 MHz. RF Data Rate 10 Kbps o 200 Kbps Indoor/Urban Range 610 m Outdoor/ Line-Of-Sight Range 35 km ( w/ 15 dB Grid antennas) Transmit Power 24 dBm (250 mW) Receiver Sensi�vity -101 dBm @ 200 Kbps, -110 dBm @ 10 Kbps Spread Spectrum FHSS (Soware Selectable Channels) Wireless LAN Compliance for IEEE 802.11 b/g/n Wireless Security: WEP, WPA, WPA2, TKIP, AES, 802.1x TX Power 11b: 15dBm /11g: 14dBm RX Sensi�vity: -66 dBm@54 Mbps, -80 dBm@11Mbps Transmission Rate : 54 Mbps (max.) con auto fallback Transmission Distance : Up to 300 meters (@12 Mbps, in open areas) Antenna Connector: Reverse SMA Topologies: Access Point, Infrastructure and AdHoc Analog Input Set of 16 analog inputs Isolaon: Opcal Three independent return references Maximum Operaonal Voltage: 32 VDC Maximum InputCurrent : 100mA Reading from Hart Instruments Hart Channels : Two Hart Configuraon: Point to Point or Muldrop Input Resistance: 150 ohm Power Requirements Input Voltage: 9- 32 VDC Current Consumpon: under 500mA (Powered with 24 VDC) Environmental Operang: -10°C ~ 60°C (14°F ~ 140°F), 5~95% HR Dimensions 45.3 mm x 107 mm x 89.6mm (W x H x D) Supported Protocols Modbus RTU Master: Supports Modbus commands 1,2,3,4,5,6,15 and 16 for baud rates from 110bps up to 115kbs using RS 485. User can congure upt to 2000 commands in the port. Modbus TC/IP Client/Server: Supports Modbus Commands 1,2,3,4,5,6,15 and 16 allowing the conguraon of mulple clients or mulple servers. Over 2000 commands can be congured for each client. EtherNet/IP Tag Based Cacces: Allows reading and wring tags in any of the Logix PLCs from Rockwelll Automaon. HTTP: The equipment could be accessed for conguraon and status check from a Web Browser. NTP Client: Allows to add a me stamp to processed data. Conguraon The embedded conguraon tool, free of charge, is web page based and could be accessed from LAN and WLAN interfaces allowing programming and conguraon of the unit. HMI Interface The Proton can provide the user with all the necessary tools for developing and using the embedded human machine interface (HMI). Orderable Part Number PRT-CMB-01, PRT-CMB-01-900, PRT-CMB-01-24, PRT-CMB-01-GSM, PRT-CMB-01-900-24, PRT-CMB- 01-900-24, PRT-CMB-01-900-24 www.proton-iot.co [email protected] [email protected] 3651 Pegasus Dr. Ste 117 Bakersfield, CA 93308. USA Ph: (661)310 2599
Transcript
Page 1: sales@proton-iot.co support@proton-iot.co 3651 Pegasus Dr ...

Lateral View

Rear View

Front View

PROTON-16AIWireless Smart RTU

Specifica�on and design are subject to change without no�fica�onAll product names referenced herein are registered trademarks of their respec�ve companies

CPU ARM9 400MHz on Atmel AT91SAM9G25Flash Memory 256 MB Nand FlashSDRAM 28MB / 256 MB DDR2Serial Port Baud Rate: 300bps –921.6 Kbps

Parity Check: None, Odd, EvenData Bits: 5,6,7,8Stop Bits: 1, 2Connector: 3 Terminal Block ConnectorProtec�on: 15KV ESDIsola�on: Magne�c.

Ethernet 10/100/1000M Auto nego�a�onProtec�on: Built-in 1.5kV magne�c isola�on

900 MHz Radio Modula�on Frequency 902 to 928 MHz.RF Data Rate 10 Kbps o 200 KbpsIndoor/Urban Range 610 mOutdoor/ Line-Of-Sight Range 35 km ( w/ 15 dB Grid antennas)Transmit Power 24 dBm (250 mW)Receiver Sensi�vity -101 dBm @ 200 Kbps, -110 dBm @ 10 KbpsSpread Spectrum FHSS (So�ware Selectable Channels)

Wireless LAN Compliance for IEEE 802.11 b/g/nWireless Security: WEP, WPA, WPA2, TKIP, AES, 802.1xTX Power 11b: 15dBm /11g: 14dBmRX Sensi�vity: -66 dBm@54 Mbps, -80 dBm@11MbpsTransmission Rate : 54 Mbps (max.) con auto fallbackTransmission Distance : Up to 300 meters (@12 Mbps, in open areas)Antenna Connector: Reverse SMATopologies: Access Point, Infrastructure and AdHoc

Analog Input Set of 16 analog inputsIsola�on: Op�cal Three independent return referencesMaximum Opera�onal Voltage: 32 VDCMaximum Input Current : 100mA

Reading from Hart Instruments Hart Channels : TwoHart Configura�on: Point to Point or Mul�dropInput Resistance: 150 ohm

Power Requirements Input Voltage: 9- 32 VDCCurrent Consump�on: under 500mA (Powered with 24 VDC)

Environmental Opera�ng: -10°C ~ 60°C (14°F ~ 140°F), 5~95% HRDimensions 45.3 mm x 107 mm x 89.6mm (W x H x D)Supported Protocols Modbus RTU Master: Supports Modbus commands 1,2,3,4,5,6,15 and 16 for baud rates from 110bps

up to 115kbs using RS 485. User can configure upt to 2000 commands in the port.Modbus TC/IP Client/Server: Supports Modbus Commands 1,2,3,4,5,6,15 and 16 allowing theconfigura�on of mul�ple clients or mul�ple servers. Over 2000 commands can be configured for eachclient.EtherNet/IP Tag Based Cacces: Allows reading and wri�ng tags in any of the Logix

PLCs from Rockwelll Automa�on.HTTP: The equipment could be accessed for configura�on and status check from a Web Browser.NTP Client: Allows to add a �me stamp to processed data.

Configura�on The embedded configura�on tool, free of charge, is web page based and could be accessed from LANand WLAN interfaces allowing programming and configura�on of the unit.

HMI Interface The Proton can provide the user with all the necessary tools for developing and using the embeddedhuman machine interface (HMI).

Orderable Part Number PRT-CMB-01, PRT-CMB-01-900, PRT-CMB-01-24, PRT-CMB-01-GSM, PRT-CMB-01-900-24, PRT-CMB-01-900-24, PRT-CMB-01-900-24

[email protected]@proton-iot.co3651 Pegasus Dr. Ste 117 Bakers�eld, CA 93308. USAPh: (661)310 2599

Page 2: sales@proton-iot.co support@proton-iot.co 3651 Pegasus Dr ...

PROTON-16AIWireless Smart RTU

Advanced Calcula�on:

In some situa�ons, it is required to be able to make advanced calcula�on algorithms such as AGA3

or AGA8; for example, this gives the user full flow control, without the need of using an expensive

flow computer. In these kinds of situa�ons, the SPX5 can operate as a math coprocessor for your

PLC by execu�ng these and other types of calcula�ons programmed using our scrip�ng language.

Mobile HMI

The Proton can provide the user with all the necessary tools for developing and using the embed-

ded human machine interface (HMI). By having access to this feature, the user could observe the

saved register values or change the process variables magnitude from anywhere. The HMI access

is granted from a computer, tablet or smartphone by using a web browser increasing the compa�-

bility of the applica�on with the selected visualiza�on device.

Scrip�ng

The Proton allows the user to program small scripts, making it easy to implement control logic

dependent on the state of the communica�ons with other devices through any of the supported

communica�on protocols. The control logic could also be addressed for changing the digital output

state or current magnitude of analog output or change the register content that could be part of a

Modbus or IZINet protocol.

The Proton is a new and innova�ve device that includes many capabili�es that allow it to assume the func�ons of several devices normally used in process control and data monitoring. The Proton can work as a remote terminal unit (RTU), Gateway, human machine interface (HMI) as well as a communica�on radio. Working as an RTU the Proton can manage a set of digital and analog input-ou-tputs. The serial and Ethernet communica�on ports ruled by wide set industrial communica�ons protocols (Modbus RTU y TCP, Ethernet IP, NTP, HTTP) allows the Proton to also work as a Gateway. Accessing the unit by a Web Browser gives the user the op�on to configure or visualize the embedded HMI. The Proton is equipped with a Wi-Fi radio that allows 24/7 access for configura�on from several devices and can be ordered with a set of 900MHz and 2.4 GHz radios for short and long radio links in a point to point or mesh topologies.

Protocol Conversion

The Proton allows the user to communicate mul�ple protocols using only one gateway. Commu-

nica�ng with these devices is made simple by using: Modbus RTU (Master or Slave), Modbus

TCP/IP (using single or mul�ple clients/servers), or Ethernet/IP. It is possible to feed the registers

using informa�on read from inputs or to define outputs values or states per the communica�ons

register contents. All these protocols and features are available in a unique device with a unique

part number, easing your procurement and spare parts inventory process

Wireless Communica�ons

The Proton can communicate with other devices using WIFI 802.11 b/g/n standard. By using this

channel, it is possible to configure the unit or get access to the human machine interface (HMI)

once it has been configured. Also, there is the possibility to order the product provided with a set

of up to two radios in 900MHz and 2.4GHz carriers in point to point or mesh topologies using the

IZI Net supported protocols.

Reading from Hart Instruments

Two of the sixteen analog inputs of the Proton16AI can read informa�on from instruments using

the Hart Protocols. The readings can be configured as point to point or mul�drop making it possi-

ble to read informa�on from up to four instruments at the same �me. The channel input resistan-

ce is 250 ohm.

EtherNet/IP

Modbus RTUModbus TCP/IP

DF1

Modbus TCP/IP

Protocol Conversion

Proton

PLC

Gas ChromatographOrifice Plate

Advanced Calcula�on

Proton

ControlLogix PLC

Mobile HMIProton

Wireless Communica�ons

ProtonProton

Proton

ProtonProton

Net 900Up to 30Mi

Net 900Up to 30Mi

Net 2.4Mesh

Net 900Mesh

Net 2.4Mesh

WiFib/g/n

2.4GHz

Scrip�ng

Proton

Modbus RTU AI_PIT

Continous ScriptingIf AI_PIT >250 PSI Then VSD_State=o� Write: Alarm ONelse VSD_Speed=1500rpm

The Proton is a new and innova�ve device that includes many capabili�es that allow it to assume the func�ons of several devices normally used in process control and data monitoring. The Proton can work as a remote terminal unit (RTU), Gateway, human machine interface (HMI) as well as a communica�on radio. Working as an RTU the Proton can manage a set of digital and analog input-ou-tputs. The serial and Ethernet communica�on ports ruled by wide set industrial communica�ons protocols (Modbus RTU y TCP, Ethernet IP, NTP, HTTP) allows the Proton to also work as a Gateway. Accessing the unit by a Web Browser gives the user the op�on to configure or visualize the embedded HMI. The Proton is equipped with a Wi-Fi radio that allows 24/7 access for configura�on from several devices and can be ordered with a set of 900MHz and 2.4 GHz radios for short and

Proton

Proton

Up to 30Mi


Recommended