Salmon Life CycleOrigami Chatterbox
Created by Molly Shea, Oregon Office © 2018 National Wildlife Federation. Permission granted for non-commercial educational uses only. All rights reserved.
Cut along dotted line
How to Fold Salmon Life Cycle Origami Chatterbox
Step One: Cut along dotted lines (when finished, you should have a square). Fold square diagonally with blank side up to make crease. Open up and fold diagonally the other way (shown in pictures below).
Step Two: Unfold so that right side is down (blank side facing up). Fold each of the four corners so that the point meets the center.
Step Three: Flip over so that the word side is facing up. Now fold each of the four corners so that the point meets the center.
Step Four: Fold in half (creases should already be made, just make them again) both ways.
Step Five: Enjoy your origami chatterbox and learning about salmon!
Questions or comments? Email [email protected]
Created by Molly Shea, December 2018 AmeriCorps Education & Outreach Coordinator, Oregon Office National Wildlife Federation and Association of Northwest Steelheaders
