Saniswiss automate aHPportable no-touch room sanitizer

Saniswiss automate aHPdisinfects invisible surfaces

Surface contamination in hospitals is involved in the transmission of patho-gens in a proportion of healthcare-associated infections. Admission to a room previously occupied by a patient colonized or infected with certain noso-comial pathogens, increases the risk of acquisition by subsequent occupants. Thus, there is a need to improve termi-nal disinfection of these patient rooms. Conventional disinfection methods may be limited by reliance on the operator to ensure appropriate selection, formu-lation, distribution and contact time of the agent. These problems can be redu-ced by using Saniswiss automate aHP.

bactericide activity comply withEN 1040, EN 14561, EN 13727,EN 1276, (< 30 seconds)• pseudomonas aeruginosa• escherichia coli• enterococcus hirae• staphylococcus aureus• proteus vulgaris• staphylococcus epidermis• MRSA• clostridium difficile cells• listeria• streptococcus pyogenes• salmonella typhimurium• shigella sonnei• klebsiella pneumoniae• proteur mirabilis

fungicide, yeasticide, activity comply with EN 1275, EN 1650, EN 13624EN 14562 (< 5 minutes)• candida albicans• aspergillus niger

tuberculosis activity complywith EN 14348• mycobacterium avium• mycobacterium terrae

spores activity complywith EN 13704• clostridium difficile spores

virucide activity (<30 secondes)• HBV• HCV• HIV• BVDV• human influenza• SRAS• vaccinia• H5N1• H1N1

activity complies with EN 14476• norovirus• adénovirus• rhinovirus• rotavirus

meets EU standards ENs

before

after

biosanitizer S is a medical device Class IIa

With Saniswiss automate aHP, you automate the tedious work that represents a manual disinfection of surfaces often sloppy due to lack of time. With it, you disinfect everywhe-re and eliminate the risk off cross-contami-nation for the staff members and patients, while ensuring optimal microbiological effi-cacy without creating germs resistance. The-se are some of the many advantages of the Saniswiss automate aHP.

The Saniswiss automate aHP will trigger the calculated disinfection of the room vo-lume to be treated and the biosanitizer ml needed. It will turn off automatically at the end of the cycle. Only a few mi-nutes are sufficient to disinfect the enti-re air and surfaces (3 minutes for 20 m3), including those that you can achieve with the naked eye.

ingeniousOur revolutionary system upsets standards of mechanical surface disinfection often ran-dom. The combination of the biosanitizer antimicrobial and the Saniswiss automate aHP brings reproducible microbiological results. The disinfection operation is carried out automatically with the advantage of not neglect some surfaces hard to reach with a wipe.

effective The microbiological activity is provided by the eco-friendly biosanitizer S, a water-based disinfectant with only <2% or biosanitizer aHP P <6% hydrogen peroxide. The Saniswiss automate aHP is equipped with a patented heated venturi-system, enhancing the micro- bial activity of the product. biosanitizer S meets the requirements of Medical Devices Directives 93/42/EEC, benefits from the SGS certification standards CE 0120 safety mark, tested according to European stan-dard testing method and tested to those of RKI and VAH in Germany. A study conduc-ted in Switzerland by a notify laboratory confirmed these results by drawing on the last French standard NF T 72 281.

0120

cost-effectivePortable, the Saniswiss automate aHP can be installed anywhere. A single automate aHP can disinfect several rooms and treats up to 350 m3. The operation requires only a minimum dose of biosanitizer (3 ml/m3). non-toxicUnlike "classical-chemical" products, biosanitizer S, aHP P and aHP C do not contain peracetic acid. It guarantees maximum safety for the user, environment and the treated material. After use, it leaves a neutral and pleasant odor in the treated room.

safeThe operation is carried out of human pre-sence safely. It leaves no trace, not wet, it isnot risk to surfaces or electronic equipment.A protocol for use supplied with the controller guarantees perfect sound job.

rapid room recoveringSaniswiss automate aHP disinfects all sur-faces and air in an average room in less than 30 minutes. The room can be used immedia-tely after aeration of its volume.

time and volume setting aerosolisation aHP

dangerous, harmful,irritant

flammable dangerous for the environment

dangerous product for the health

bsa0

5201

6EN

santé : salle d’opération, chambre d’hôpital, cabinet dentaire, ambulance, laboratoire...

Saniswiss automate aHPmultiple fields of use

developed for the healthcareOriginally, our system of automatic airborne disin-

fection was developed to address the crossinfection

issues of healthcare professionals, such as: hospitals,

medical offices, dental offices, laboratories, homes

retirement, rehabilitation places, places of quarantine

and ambulances.

useful elsewhereThe problem of infection control is not limited to

specific areas of medicine. For this reason our sys-

tem may be used in various application areas such

as: transport (air, rail, maritime, road), nurseries,

schools, child care, restaurant, police, industries,

hotels and funeral.

characteristicspower 1000 W

tension 230 V

frequency 50 to 60 Hz

intensity 4,5 A

maximum intensity 10 A

speed of turbine 22000 t/min

tank capacity 750 ml

weight 9,8 kg

net weight 9 kg

size W 29 x H 39 x L 53,6 cm

performancesspeed-exit of air 80 m/s

max. volume to be treated 350 m3

average output 350 ml/h

consumption 3 ml/m3

optionstimer, wall-adapter,

bottles 750 ml, 1000 ml, can 5000 ml

saniswiss sa • chemin des tulipiers 19 • 1208 Genève • Switzerland • t +41 22 718 75 75 • f +41 22 718 75 76 • info@saniswiss.com • saniswiss.comsaniswiss sa is an ISO 13485 certified compagny.