SECTION 6.8 VOYAGER FOLLOWSPOT

Catalog Number Description Section Voyager Voyager Follow Spot (Full Drawing) 6.8.1 Voyager Lower Housing 6.8.2 Voyager Lamp & Douser 6.8.3 Voyager Shutter & Iris 6.8.4 Voyager Rear Focus 6.8.5 Voyager Front Lens 6.8.6 Voyager Fine Focus 6.8.7 Voyager Rear Track 6.8.8 Voyager Electrical 6.8.9 Voyager Hood 6.8.10 77-0117 Voyager Color Changer 6.8.11 78-0609 Voyager Yoke 6.8.12 Voyager Stand 6.8.13 Document Voyager Short Throw Follow Spot (Future) Section 6.10

ARCHITECT’S & ENGINEER’S SPECIFICATIONS

The luminaire shall be a 400W follow spot designed to accept only the 400W HTI lamp. The lamp shall be mounted on a factory pre-focused adjustable mounting plate. The fine focus lamp adjustment shall be located at rear of housing. Each unit shall be provided with an adjustable 4 ½” Plano convex objective lens and 11” Plano convex front lens to achieve a variable zoom range of 0.5 to 9.5 degrees. The front lens shall be provided with an adjustable drag control to prevent unwanted lens movement at extreme angles. Relamping to be accomplished through hinged lamp access door, without the use of tools or disturbing the pre-focused lamp alignment. The luminaire shall be supplied with separate fan and lamp switches; 6 lever self-canceling color boom, clam shell douser, and regulated power supply for either 120VAC/10 amps or 240VAC 5amps as specified. The trouping stand shall be provided with four locking casters, leveling jacks and positive lock pan, tilt and height controls. The power lead shall be a removable three-conductor type S cord with GTL connector at lamp house and parallel blade U-ground plug for connection to service. Exterior shall be black wrinkle finish. The light output shall be a maximum of 8.5 million-beam candlepower in spot and 2.5 million-beam candlepower in flood. The luminaire shall be the Altman Voyager