SB10-002
1/16
SUBARU SERVICE BULLETIN
Pub. No. SB10-002 Issued: January 27, 2010 Fuji Heavy Industries Ltd.Service Dept. Printed in Japan
Subject: New service parts information, diagnosis procedure and replacement procedure of Suction Control Valve
Applicable System: Engine
Applicable Parts: Suction Control Valve of high pressure fuel supply pump
Foreword: This is to announce new service parts information, diagnosis procedure and replacement procedure of Suction Control Valve.
Applicable Model Spec MY
LEGACY Diesel for Europe 08, 09
FORESTER Diesel for Europe 09, 10
IMPREZA Diesel for Europe 09, 10
1. Content There is a possibility that Fuel flow produces cavitation erosion on the surface of Suction Control Valve (SCV) needle. Negative pressure peels plating film on the surface of SCV needle. The peeled plating film interferes with the movement of the high pressure fuel supply pump. It causes engine stall, rough idle or smoke exhaustion. In this case, you can replace only SCV to solve it. Therefore, we revise “Diagnostic Procedure without Diagnostic Trouble Code (DTC)” for diesel engine in Service Manual and set up SCV as service part.
2. Part number and name of SCV 16626AA000 VALVE AY-FUEL CONT
3. VIN Break We improved durability of SCV against cavitation from start of production for 09MY Forester, 09MY Impreza and 10MY Legacy. VIN Break is as follows.
LHD RHD Model
MY Sedan Wagon Sedan Wagon
Forester 2009 042674 015293
Impreza 2009 - 050890 - 028206
Legacy 2010 002094 002172 003116 004063
SB10-002
2/16
4. Diagnostic Procedure
Suction COMMON RAIL
Terminal NO. is arbitrarily
Terminal NO. 1, 2, 5 or 6 is arbitrarily located
*1
*2
SB10-002
3/16
SB10-002
4/16
18460AA010
(E131) No.46 (+)-(E131) No. 76 (-):
SB10-002
5/16
SB10-002
6/16
A±3,000 B±3,000 C±3,000
SB10-002
7/16
SB10-002
8/16
A±3,000 B±3,000 C±3,000
SB10-002
9/16
SB10-002
10/16
SB10-002
11/16
SB10-002
12/16
5. Procedure of removal and install
SB10-002
13/16
SB10-002
14/16
SB10-002
15/16
SB10-002
16/16
End