All other trademarks are property of their respective owners.
M6 x 15 SEMS PPHS(re-use)
Codec BracketM5 Knurled-
Head Screw (1)
M3 x 5 PhillipsFlat Head Screw (4)
M6 x 15 SEMSPPHS (4)
Display Brackets (2)1
Two Displays
M3 x 10 PhillipsPanhead SEM-INT
Screw (2)
M4 x 16 PhillipsPanheadScrew (2)
M3 x 10 PhillipsPanhead SEM-INT
Screw (2)
Setting up the Polycom® RealPresence® Group SystemTabletop Media Center
2
23
2
M4 x 16 PhillipsPanhead
Screws (2)
5
M4 x 16 PhillipsPanheadScrew (2)
M6 x 15 SEMSPPHS
One Display Two Displays
24
One Display
Two Displays
Setting up the Polycom® RealPresence® Group SystemTabletop Media Center
3
6
M3 x 5 PhillipsFlat Head Screw (4)
One Display
Two Displays
7
M5 Knurled-Head Screw (1)
Setting up the Polycom® RealPresence® Group SystemTabletop Media Center
4
168
RPG 500 only
Two Displays
One Display
RPG 500 only
Only Polycom RealPresence Group Systemcomponents should be plugged into the poweroutlet block. Do not power any other electricalequipment from this power outlet.
Setting up the Polycom® RealPresence® Group SystemTabletop Media Center
5
16
Regulatory Notices: This equipment is intended for indoor use only. Only use this equipment with the display(s) supplied by Polycom. Do not use a power cord that is damaged. This could cause fire or electric shock. Contact the manufacturer for a replacement cord, if necessary. Only use a power cord which is appropriately rated and approved relevant to the country of use. This equipment should be used only on even surfaces. When connecting to the mains supply, connect only to an earthed supply outlet which is installed near the equipment and is easily accessible. Keep ventilation openings free from any obstructions. The ambient operating temperature rating of this equipment is 0 - 40ºC and should not be exceeded. Do not immerse the system in any liquid or place any liquids on it. Do not spray liquids directly onto the system when cleaning. Always apply the liquid first to a static-free cloth. For further information concerning the individual components of this equipment, please refer to the respective product literature. For support or service, please contact your Polycom® distributor or go to Polycom Support at www.polycom.com/support.
Power Rating:Voltage rating: 100-240 VAC, 50/60Hz
Maximum power consumption (configured with GroupSeries 500 codec and EagleEye IV camera under fullload operating conditions):
Single 42” display: 171.4WDual 42“ displays: 231.4W
Approximate system weight (including display(s),codec, and camera):
Single 42” display: 62.7 lbs.Dual 42” displays: 123 lbs.
