Shallow Mounted Hydraulic Road Blocker
Installation Manual
1.1 Overview
Hydraulic road blocker is applied in important area where has high security
requirement such like government building, airport, energy base, military, bank to
access control vehicles. Stop all unallowable vehicles. It can be operated by remote
controller, push button and various kinds of access control system. Main advantages are
high-frequency use, robust body, reliable hydraulic unit, good expansibility, low maintain
cost
Shallow mounted road blocker base depth is only 400mm. Such design can save
installation cost and reduce installation difficulty. Shallow amounted road blocker is the
best choice for site where there are cables, wires and other equipment in ground.
1.2 System configuration
Hydraulic road blocker includes two main parts--- power system and road blocker body.
① Power system includes hydraulic unit and control system. This is the core
of entire road blocker system. Max distance between power system and
road blocker body is 20M
② Road blocker body is mechanical structure. This parts is installed in
run-in/run-out to control vehicles.
Road blocker technical parameter
Brand Deloul
Height 950mm
Width 2 m、 3m、4m、5m (can be customized)
Weight 1.8T~3T
Blocker material Thickness 20mm carbon steel
Surface finish Galvanized and powder coated
Rising speed 3~6s adjustable
MTBF 2 million, ( usable frequency :2000times per day)
IP level IP67
Impact resistance 7,000,000ton
Status after power off Keep original status(can be operated by manual)
6
Road blocker technical parameter
Power 3.75KW、5.5KW
Voltage Motor:AC 380V Controller:DC 24V
Oil viscosity 32cst(40℃)
Oil container volume 60L
Oil pressure 9MPa~14MPa
Temperature -20~60℃
Control signal Relay signal>100ms Dry contact signal
Accessories Traffic light, loop detector, RFID card reader
(not included in quotation)
Note:
① By default,road blocker is operated by remote controller and
push button
② Distance between power cabinet and mechanical structure should
be less than 20M
7
2 Products
2.1 Power cabinet
① Control system
② Hydraulic pump
8
Note:
1. Electric control part: give signal to control system to make road blocker up and
down,can be compatible with LED light, loop detector, access control system etc.
2. Hydraulic pump:It’s power unit for road blocker.
3. handle bar:Users can operate road blocker via handle bar when power is fail
9
3 Installation
1. Make base and embedded pipe/wire
According to installation drawing to dig hole, make base and install embedded
pipe as following step
① Installing one PVC 50 pipe between road blocker machine and power
control cabinet. Put 2 oil tubes and one RVV4*0.5 wire in PVC
② Installing one PVC 25 between power cabinet and power distributor room,
put one RVV4*4.0 power cable in PVC
③ If push button will be installed in guard room, installing one PVC 25
between power cabinet and guard room, put one RVV3*0.5 signal wire in
PVC
2. Put road blocker machine on base, fill the hole by concrete.
Make ensure the road blocker is horizontal
3. Connecting oil tube, power cable and signal wire
Products have been done ageing testing and all wire, equipment in power
cabinet are finished configuring before delivering. Wires/cable from power
cabinet to road blocker machine need to be connected in project site.
There are 2 oil tubes and one RVV4*0.5 limit line between road blocker
machine and power cabinet.
4. Other accessories configuration、debug the entire system
Other accessories includes LED lights, loop detector, infrared sensor, access
control systems
4 Use manual
Two ways to operate road blocker
Push button
Remote controller
13
Operated by manual
Motor Wire
Oil
containe
Handle bar