Single Stage Vane Separator
The Seaworth Single Stage Separator system is designed to eliminate moisture ingress where space restrictions indicate the need for high velocity and large water volumes are evident.
Construction:
The Seaworth Vane Separator units are constructed in aluminium with anodised vanes and powder coated casing. The units are robustly constructed and are suitable for a harsh marine environment. The Seaworth Separator unit will operate up to 6.1m/sec with a normal design velocity of 5.0m/sec.
Seaworth Single Stage Separators are included on Z-Tech Tug “FARFAN”: Photo courtesy of Cheoy Lee Shipyard Ltd
Vane Separator:
The Single Stage separator achieves maximum possible water loading with minimal weight and pressure losses. Air drawn through a series of specially designed vanes which trap water, which then drains verti-cally down to the drainage channel and finally out the front drain slot or into a Manometric drain trap.
Front and Rear flange options are available depending on project requirements. Contact Camfil NZ for details on options available.
Mounting: Seaworth Separator units are supplied with predrilled flange, 316 st/st countersunk screws, nylon insulators and neoprene flange gasket.
Sizing Information Height Width Vessels Opening H W Over Flanges H + 60mm W + 60mm
Open Face Size H - 130mm W - 60mm
Overall Depth: 75mm
This data is guideline only and is subject to change. For further information please contact Camfil New Zealand Ltd
www.seaworth.com
Manufactured By: Camfil New Zealand Ltd
PO Box 531, Albert Street Cambridge, New Zealand
[email protected] PH: +64 7 827 4142
Performance
Water Handling 24 Ltr/min per mtr Capacity width
Maximum Face 6.5m/sec Velocity VTT Expert Services Tested at 5.0m/sec
Rated "A" (100%)