Home > Documents > Sketching Basic Kicker System Parameters W. Bartmann, T. Fowler, B. Goddard, T. Kramer.

Sketching Basic Kicker System Parameters W. Bartmann, T. Fowler, B. Goddard, T. Kramer.

Date post: 21-Jan-2016
Category:
View: 250 times
Popular Tags:
of 9 /9
Sketching Basic Kicker System Parameters W. Bartmann, T. Fowler, B. Goddard, T. Kramer
Transcript

Sketching Basic Kicker System Parameters

W. Bartmann, T. Fowler, B. Goddard, T. Kramer

Motivation• Increase number of kicker modules such that each

module only contributes a kick below system endangerment thresholds.

• Investigate a segmented system to: • Limit beam perturbations by pre-fired kicker(s)• Subsequently avoid asynchronous beam abort.• Limit the consequences of missing modules

during beam extraction. • Ease the feasibility of (several) redundant

modules (hot spares).

Summary of 1st assumption (last meeting)

• Total required FCC MKD kick: 0.15mrad (25T.m) (for layout with Quad-window)

• Available beam line length: ~100m; b=500m• Max. acceptable kick on circ. beam: 2.75σ → 0.75µrad• 200 modules are needed for an individual module

Probably too high – should be reduced to 1σ to stay on the safe side.

Reduce to 150m.

Relation between max. acceptable kick, max. kick per module and beta

0 100 200 300 400 500 600 700 800 900 10000

0.5

1

1.5

2

2.5

x/s=0.5x/s=1x/s=1.5x/s=2x/s=2.5

beta [m]

k [µ

Possible system configuration

• Assuming design based on LHC MKD like magnet.• For b=150m and max. perturbation of 1s a max. kick of 0.52µrad/module is allowed.• Total system would consist of 290 +10 spares = 300 modules. • B.dl = 0.0862T.m per module; module kick: 0.517µrad• Module length 30cm -> 87m mag. length; total physical length ~125m• Module length 26cm -> 75.4m mag. length; total physical length ~112m

1 6 7 12

2.2

4.8

0.05 0.40.3

Reference for assumptions: LHC MKD system

Distances between magnets:• Chamber head: 46 mm (LHC MKD)• Usually 120 mm between magnets but: • 400 mm for vacuum pump between every 2nd magnet

(~3 m) and 275 for valve every 5th magnet (~8m)

Kept the same as 1st assumption - to be evaluated with vacuum specialists.

Magnet Parameters

• B-field: 0.29 T • Inductance L for squared aperture of 36mm: Lm= 0.4µH• Current: I= 8.3 kA• Required Voltage: 5.25 kV (t.b.c) • Generator main capacitance: 1.02 µF

Parameters (per module)

B.dl [T.m] 0.0862

Length [mm] 300

Aperture (h) [mm] 36

Still to be done• Basic design of pulse generator

• Switch and main capacitor circuit • Freewheel circuit• Droop compensation ( 350µs!) • Switch trigger circuits

• Integration aspects• 3D Magnet size • Vacuum System • Switch (stack) size • Capacitor sizes

• Etc …

Recommended