QA-080110[1/13]

SPECIFICATION FOR

SLPB8643128H5

Superior Lithium Polymer Battery

1. Make certain that the Handling Precautions should be read before using Kokam products.2. May have different graphs pattern from provided ones according to test conditions

(eg. temperature, equipments etc.)3. No responsibility for improper installation or transformation.

QA-080110[2/13]

Dimension

QA-080110[3/13]

7

282 Wh/lVolumetricEnergy Density8

145 Wh/Gravimetric

2

at 1kHzMAX. 3.0AC-Impedance(mΩ )5

4

3

Weight(Max.)

Discharge ConditionCut-Off Voltage

Max. CurrentCharge Condition

Nominal Voltage

-20 ~ 60Discharge

Continuous current30.0C(108,000mA)

1.0C(7,200mA)

Max. Current

Voltage 4.20 ± 0.03 V

3.7 V

TYP. 3,600mAh

101.0 g

0 ~ 45ChargeOperating Temperature6

2.7 V

Nominal Capacity *11

REMARKSSPECIFICATIONITEMSNO

*1. Nominal Capacity : 0.2C(720mA), 2.7V cutoff Average Discharge Capacity

Specification

QA-080110[4/13]

Performance

> 85 %20.0C / 0.2C

> 80 %30.0C / 0.2C

> 75 %1 Month at 60

23

1.0C / 0.2C

0.2C(720mA)

3

• On a storage, Cell state is 40%~50%

charge(3.7~3.9V).

> 90 %6 Months at 23 Storage Characteristics

[Recovery Capacity]4 > 80 %3 Months at 45

100 %2

Cycle Life Characteristics

[Charge : 1.0C(3,600mA),CC/CV, 4.2V,0.05C(180mA) Cut-off

Discharge : 1.0C(3,600mA),CC,2.7V ]

Discharge Characteristics [Temperature Dependence of Capacity]

45

10.0C / 0.2C

> 75 %-10

• Percentage of 23±3 Capacity is 100%.

• On the standing setting temperature,

Cell state is full-charge(4.2V)

• Interval for temp. change is 2Hr

• Measured with discharge current

0.5C(1,800mA) with 2.7V

> 95 %

> 95 %

60

> 98 % • Test Temperature ; 23±3• Charge : 0.5C(1,800mA),CC/CV,4.2V

0.05C(180mA) Cut-off

• Discharge : Each C-Rate,CC,2.7V

100 %

• More than 80% of Initial capacity> 500 Cycles

> 85 %0

> 97 %

Discharge Characteristics

[C-Rate Dependence of Capacity]

1

REMARKSCRITERIONITEMSNO

QA-080110[5/13]

Fresh

Fresh

Fresh

Fresh

Fresh

Fresh

CONDITIONSTATE

Impact

Crush

Heating

Short Circuit

Forced

Discharge

Over Charge

ITEMS

9.1kg at

61cm6

Charge

1.3mm2 Cu

Wire3

No Explosion

No fire

No Explosion

No fire

No Explosion

No fire

No Explosion

No fire

No Explosion

No fire

No Explosion

No fire

RESULT

Discharge

Charge

BATTERY

4

UL1642Charge13kN

Pressure5

UL1642Charge

2

10min

at 150

1.0C

for2.5Hr

UL1642Charge

UL1642

SBA G1101

UL1642

1.0C/12V1

REMARKTEST

METHODTESTNO

Safety

QA-080110[6/13]

Charge Characteristics

0 20 40 60 80 100 120 140 160

3.0

3.2

3.4

3.6

3.8

4.0

4.2

0

1000

2000

3000

4000

5000

6000

7000

8000

Curre

nt(m

A)

& C

apacity

(mAh)

Voltage (V)

Time (min)

Charge : CC-CV,0.5C(1,800mA), 4.2V, 0.05C(180mA) Cut-off @ 23±3 Charge : CC-CV,2.0C(7,200mA), 4.2V, 0.05C(180mA) Cut-off @ 23±3

QA-080110[7/13]

Discharge Rate Characteristics

Charge : CC-CV, 0.5C(1,800mA), 4.2V, 0.05C(180mA) Cut-off @23±3 Discharge : CC, Each C-rate, 2.7V Cut-off @23±3

0 500 1000 1500 2000 2500 3000 3500 4000

2.8

3.0

3.2

3.4

3.6

3.8

4.0

4.2 1 .0C

5 .0C

10 .0C

15 .0C

20 .0C

25 .0C

30 .0C

Voltage(V)

C apacity(mAh)

QA-080110[8/13]

Discharge Characteristics

Charge : CC-CV, 0.5C(1,800mA), 4.2V, 0.05C(180mA) Cut-off @23±3 Discharge : CC, 0.5C(1,800mA),Each Temp., 2.7V Cut-off

After Stand During 2Hr at Test Temperature

0 500 1000 1500 2000 2500 3000 3500 4000

2.8

3.0

3.2

3.4

3.6

3.8

4.0

4.2 60

oC

45 oC

25 oC

0 oC

-10 oC

Voltage(V)

Capacity(mAh)

QA-080110[9/13]

Cycle Life Characteristics

Charge : CC-CV, 1.0C(3,600mA), 4.2V, 0.05C(180mA) Cut-off @23±3 Discharge : CC, 1.0C(3,600mA), 2.7V Cut-off @23±3

0 100 200 300 400 5000

500

1000

1500

2000

2500

3000

3500

4000

Capacity(mAh)

Cycle(Number)

QA-080110[10/13]

Handling PrecautionsPlease read and follow the handling instructions for the battery before use. Improper use of the battery may cause heat,

fire, explosion, damage or capacity deterioration of the battery. However, the manufacturer will not guarantee against any

accident caused by the usage which is not written here.

DANGER

1 Do not disassemble or modify the battery. This will destroy the safety features built in the battery, and

result in un-expected dangerous troubles.

2 Do not connect the positive (+) and negative (-) terminals with metal objects such as wire.

3 Do not transport or store the batteries with metal objects such as necklace, hair pin etc. Otherwise, short-

circuiting will occur, over-current will flow, causing the battery to overheat, smoke emission, bulge or ignite.

4 Do not throw the battery into a fire or heat it.

5 Do not dip or wet the battery in water, seawater or any types of liquid.

6 Do not use or store a battery at high temperature, such as in strong direct sunlight, in cars during hot

weather, or directly in front of heaters.

7 Do not apply any impact to the battery, or throw away or drop it. Strong impact should damage the battery

structure which may result in heat generation, smoke emission or ignition of the battery.

8 Do not drive a nail in, hit with a hammer, or stamp on the battery. Any abnormal stress will cause

unexpected accidents.

9 Do not forget to ensure correct connection of terminals, positive (+) and negative (-) in the charger or any

equipments in usage.

QA-080110[11/13]

Handling Precautions10 The battery to be charged must be placed on a non-flammable, heat resistant and non-conductive

surface. Keep inflammable and volatile materials well away from the charging area. Batteries must not be

left on charge unsupervised.

11 Do not charge the battery at a point above 4.2V per cell. Otherwise, the battery would be damaged

permanently that can not be recovered.

12 Do not use any unqualified or not specified chargers by Kokam, and should keep the charging process

specified by Kokam. Otherwise, it will cause heavy and/or permanent damage to the battery.

13 Do not discharge the battery at a point below 2.7V per cell. Otherwise, the battery would be damaged

permanently that can not be recovered.

14 Do not connect the battery directly to an electric outlet or cigarette heater socket in a car. Applying a

high voltage might generate an excessive current, and get an electric shock. Possibly leads to leak

electrolyte, heat generation, smoke emission or ignition.

15 Do not use the battery for a purpose other than those specified. Otherwise, its guaranteed performance

will be lost and/or its service life will be shortened. Depending on the equipment in which the battery is

used, excessively high current can flow through battery, possibly damaging it and leading to leakage, heat

generation, smoke emission or ignition,

16 In the event of electrolyte comes into contact with eyes, immediately wash thoroughly with clean water,

and consult a physician.

17 Be careful that conductivity material should not touch on the surface of battery.

QA-080110[12/13]

WARNING

1 Do not use the batteries mixed with primary batteries like dry batteries, other types of rechargeable like Ni-

Cd or Ni-MH or different capacity/voltage/manufacturer’s,

2 Stop charging process after predetermined charging period has elapsed, even though the batteries are

not fully charged. Otherwise, the battery cause heat generation, smoke emission or ignition.

3 Do not put the battery in a microwave oven or a pressure cooker. Excessive heat could damage the seal of

the battery and it will result in heat generation, smoke emission or ignition of the battery.

4 If you notice any malodor, heating, discoloration, deformation, or any other change from what you are

used to while using, charging, storing the battery, take it out of equipment or charger, and stop using it.

5 If the battery leaks or emits a malodor, take it away from any exposed flame immediately. The electrolyte

may catch fire, which may cause heat generation, smoke emission or ignition.

6 Do not use the battery in the place where the static electricity (more than the limit of the manufacturer's

guarantee) exist.

7 Operating Environment;

Charging the battery : 0 ~ +45 Discharging the battery : -20 ~ +60

Stored up to 30 days : -20 ~ +50 (SOC 50 %)

Handling Precautions

QA-080110[13/13]

CAUTION

1 Do not use or leave the battery in a place exposed to strong direct sunlight, or in a car under the blazing

sun, or high temperature sources. Otherwise, its guaranteed performance will be lost and/or its service life

will be shortened.

2 If any abnormal appearance occurs such as odors, discoloration, deformation or overheating, remove the

battery from the device and stop using.

3 Store the battery in a location where children cannot reach it. Also, make sure that a child does not take out

the battery from the battery charger or equipment.

4 If the battery leaks and its electrolyte contact with skin or clothing, wash it well with clean water right away.

Otherwise, skin inflammation can occur.

5 Follow the instructions of your equipment regarding the battery installation, and in any event of abnormal,

remove the battery from the equipment so as not to misuse and waste the battery.

6 The battery would be delivered with SOC 50% for safety purposes. In case of your equipment will not work

with this condition, you need to charge fully your battery before using.

7 In case of the battery terminals are contaminated, clean the terminals with a dry cloth before use.

Otherwise, it could result in insufficient power supply and/or failure in charging.

8 Read carefully and follow the instructions for the specified charger to learn how to charge the battery.

Handling Precautions