Date post: | 25-Mar-2019 |
Category: |
Documents |
Upload: | duongthuan |
View: | 230 times |
Download: | 0 times |
smps cum battery charger 12V 10AFeatures
?
?
?
?
?
?
?
?
?
?
?
?
?
Latest state-of-the-art current mode PWM controller and MOSFET based design.
Maximum output power of 150W. High efficiency, high reliability and low cost. Input voltage range 150 ~ 300V @50Hz. Built-in EMI filter. Low ripple and noise. Soft start circuit to limit the AC inrush current.
Compact and light weight. Momentary output short circuit protection, over voltage protection. 100% Full load burn-in test.
Screw type input and output connectors.
Fuse type reverse battery protection. Low battery cutoff at 11V DC.
ssm1210BC
battery charging characteristics
11.4
11.6
11.8
12
12.2
12.4
12.6
12.8
13
0 5 10 15 20 25 30 35 40
0
0.125
0.25
0.375
0.5
0.625
0.75
0.875
1
Time (Hr)
Graph for SMPS cum Battery Charger 12V 10A
VO
LTA
GE
CU
RR
EN
T
*Charging characteristic is subject to change according to battery capacity.
Battery Manufactured by : Exide Industries Ltd.Battery Model : 12XT7B-B (Lead Acid battery)(2 Batteries in Parallel)Charger voltage set at 14.5VDC.Room Temperature : 30 Deg.C.
Test Conditions :
S. G :- Specific Gravity
S.G < 1.1Fully Discharged
S.G = 1.130
S.G = 1.145
S.G = 1.155
S.G = 1.190S.G = 1.200
S.G = 1.220
specifications
12-15 V
8A for load and 2A for battery charging
Five 2-pin screw type connectors
a) Output Ok – Green colour LED b) Low battery indication – Orange colour LED c) OVP – Red colour LED
Output Characteristics
EnvironmentalCharacteristics
70%
GeneralCharacteristics
Output voltageOutput current
Maximum output power
Output connector
Output indication
Output protection
Line regulation
Load regulation
Ripple and noise
Input voltage
Input frequency
Input indication
Filter
Input protection
Operating temperature
Maximum temperature rise
Cooling
Relative humidity
Efficiency
Hold time
Dimension(LXWXH)
InputCharacteristics
150 W
a) Over voltage protection b) Fuse type reverse battery protection
< +/- 0.5%
< +/- 0.5%
< +/- 1% P-P
150 - 300 V
45 - 60 Hz
3-pin screw type connector
EMI/RFI
a) 4A, 20mm fast blow, glass fuseb) MOV for input over voltage protection
55°C at Full Load and 70°C at 60% Load
50°C
Free air convection
95% NC
> 20msec on full load
162 X 100 X 62 mm
Input connector
Input Ok – Yellow colour LED
Mounting Panel mounting
1) 2) For continuous improvement, specifications are subject to change without prior intimation.3) Designed for charging only one 12V 14AH battery/ two 12V 7AH batteries in parallel.
All these parameters are specified at 230V, @50Hz, at room temperature of 27°C.
note
+919823315380, +919765557595, +919765557597.+919765557596,
+91 (07104) 232292, 235216.
www.sanstarindia.com
SANSTAR MICROSYSTEMS P R I V A T E L I M I T E D
EL-15, ELECTRONIC ZONE, MIDC HINGNA ROAD, NAGPUR-440016.
Mechanical specification
3D view of complete box
Cover
PCB
Base Plate
All are inner dimensions.All dimensions are in mm.