Solar Carport System - au.mbt-energy.com · 2015-12-01 · mail on [email protected], or your...

Mibet (Xiamen) New Energy Co., Ltd.

No 69, Xintian Rd., Jimei District, Tel: +86592 3754999

Xiamen, China 361022 Fax: +86 592 6771575

www.mbt-energy.com Email: [email protected]

1

MRac Solar Carport System

Installation Guide

Content 1 Product Introduction ------------------------------------------P2

2 Installation Tool & Components-------------------------------P3

3 Installation Procedure -----------------------------------------P4

4 Warranty--------------------------------------------------------P8



Xiamen, China 361022 Fax: +86 592 6771575


2

1. Product Introduction

MRac Carport System is uniquely designed applying to large scale

commercial and utility system, offering shades to your cars while much

environment-friendly.

Please read this Installation Guide thoroughly before installing the MRac

Carport system. This Guide offers the planning and installation

instruction for MRac Carport.

MRac Carport products, when installed in accordance with this guide,

will be structurally adequate and will meet the local standards. During

installation, especially when working on the roof, be sure to observe the

appropriate safety regulations and please pay attention to the relevant

regulations of your local region. Please check that you are using the

current version of the installation manual by contact Mibet Energy by

mail on [email protected], or your local representative.

The installer is solely responsible for:

Complying with all applicable local or national building codes,

including any that may supersede this manual;

Ensuring that MRac and other products are appropriate for the

particular installation and the installation environment;

Using only MRac parts and installers-supplied parted as specified by

MRac (Substitution of parts may void the warranty and invalidate the

letter of certification on page 2);

How to recycle: according to the local relative statute;

How to disassemble: countermove with installation;

Ensure that there are no less than two professional workers in panel

installation;

Ensure the installation of relative electrical equipment is

performance by professional electrician.

Ensure safe installation of all electrical aspects of the PV array.



Xiamen, China 361022 Fax: +86 592 6771575


3

2. Installation Tool & Components

2.1 Installation Tool

L-Inner Hexagon

Spanner

Monkey Spanner Socket Wrench Electric Tool

Nylon Wire Tape Square Marker

2.2 Components List

Components List

Full-edge End Clamp Kit

U27 Inter Clamp Kit Rail 115 Rail 115 Connector

Beam 100 Beam 100 Connector C Clamp Kit Carport T-shape Jointer Kit



Xiamen, China 361022 Fax: +86 592 6771575


4

Carport Basement 80*80 Square Tube

2.3 Carport System Overview

（1）Full-edge End Clamp Kit （2）U27 Inter Clamp Kit

（3）Rail 115 （4）C Clamp Kit （5）Beam 100

（6) Carport T-shape Jointer Kit

（7）Carport Basement （8）80*40 Square Tube

②

①

③

④

⑤

⑥

⑦

⑧



Xiamen, China 361022 Fax: +86 592 6771575


5

3. Installation Guide

3.1 Install Each Unit

3.1.1

Fix the Carport

Basements onto the

pre-made concrete

bases according to the

technical drawing

provided, place the

nuts without fastened;

make sure all the

Carport Basements are

in a line both vertical

and landscape by a

Nylon Wire.

Showed as Drawing 1,

2, 3, and 4.

Nylon Wire

All basements have to be in

a line vertically

Nylon Wire

All basements have to

be in a line landscape

Drawing 1 Drawing 2

Drawing 3

Drawing 4



Xiamen, China 361022 Fax: +86 592 6771575


6

3.1.2

(1). Pre-assemble the

C Clamp Kit 150 onto

the T-shape Carport

Jointer by M8*25

bolts, as Drawing 5.

(Don’t fasten the

bolts tightly for the

convenience of next

step)

(2). Slide the

pre-assembled

T-shape Carport

Jointer to the

planned position on

the Beam 100, then

fasten the bolts

tightly now. Showed

as Drawing 6&7.

(3). Assemble the 80

Square Tube onto

the T-shape Carport

Jointer by M20*130

bolts.

Showing as Drawing

8&9.

Drawing 5

Drawing 6

Drawing 7



Xiamen, China 361022 Fax: +86 592 6771575


7

(4). Connect the

pre-assembled

Beam 100 Support

with the Carport

Basements, which

have already been

installed onto the

concretes, by

M20*130. 3 to 4

experienced worker

need to cooperate

to finish this step as

Drawing 10&11

showed.

Note: Make sure all

the bolts in this

system are

assembled from the

same direction as

showing in Drawing

12.

Drawing 8

Drawing 9



Xiamen, China 361022 Fax: +86 592 6771575


8

Drawing 10

Drawing 11

Keep all the nut in the same

direction for the whole system

Drawing 12



Xiamen, China 361022 Fax: +86 592 6771575


9

(5). Repeat above step

as per the technical

drawing suggested till

the whole system

finished.

Note: Make sure all

the bolts should be

fastened tightly.

3.2 Install Rail

3.2.1

The drawings

shows how the

Cross Module

being installed,

which is the main

component in C

Clamp Kit, Inter

Clamp Kit and End

Clamp Kit.

3.2.2

Check the length

of Rail 115, using

the Rail 115

Connector to

extend it

according to the

technical drawing

before assembled

onto the Beam.

8pcs of bolts are

required for each

side, totally 16pcs

bolts for one Rail

115 Connector.

Note: Not

recommend

extending the Rail

Rail

115

Rail 115

Connector

Drawing 13



Xiamen, China 361022 Fax: +86 592 6771575


10

115 after

assemble the Rail

115 onto the

Beam.

3.2.3

Assemble Rail 115

onto the Beam

according to the

technical drawing,

a marker can be

used to mark the

right position, as

Drawing showed.

3.2.4

Assemble all the

Rail 115 as

planned.



Xiamen, China 361022 Fax: +86 592 6771575


11

3.2.5

Fix the Rail 115

onto the Beam by

C Clamp Kits,

fasten all M8

inner hexagon

bolts.

Note: 2 sets of C

Clamp Kits need

to be used in

each side as

showed.

3.2.6

Repeat above step

and get all Rail 115

assembled as

technical drawing

planned, make

sure the end of all

rails in a line.

Note: All bolts

have to be

fastened tightly.



Xiamen, China 361022 Fax: +86 592 6771575


12

3.3 Install Panels

3.3.1

a. Place the

panels according

to technical

drawing (Drawing

1: Section view),

fix the panel by

Full-edge End

Clamp Kit and

U27 Inter Clamp

Kit.

b. Repeat above

step, and make

sure all the

panels are being

installed

properly.

Drawing 1: Section view

Installation of End

Clamp Kit



Xiamen, China 361022 Fax: +86 592 6771575


13

3.3.2

Installation

completed, check

all the bolts have

been fastened.

Installation of Inter Clamp Kit

No slot should be

remained between two

rows



Xiamen, China 361022 Fax: +86 592 6771575


14

Warranty Declaration

Mibet (Xiamen) New Energy Co., Ltd. (hereinafter as “Mibet Energy”)

warrants to the original purchaser (“Purchaser”) of product(s) that it

manufactures (“Product”) at the original installation site that the

Product shall be free from defects in material and workmanship for a

period of ten (10) years, except for the anodized finish which shall be

free from visible peeling, or cracking or chalking under normal

atmospheric conditions.

Warranties and guarantees can only be claimed if the installation and

commissioning of the photovoltaic system was done by professional

personnel, as can be proved. We guarantee a 10 year warranty for the

durability of all our MRac PV mounting products that are correctly

mounted, installed and used as our Installation Guide says.

Mibet Energy shall not be liable for consequential, contingent or

incidental damages arising out of the use of the Product by Purchaser

under any circumstances. If within the specified Warranty periods the

Product shall be reasonably proven to be defective, then Mibet Energy

shall repair or replace the defective Product, or any part thereof, in

Mibet Energy’s sole discretion. Such repair or replacement shall

completely satisfy and discharge all of Mibet Energy’s liability with

respect to this Limited Warranty. Under no circumstances shall Mibet

Energy be liable for special, indirect or consequential damages arising

out of or related to use by Purchaser of the Product. Manufacturers of

related items, such as PV modules and flashings, may provide written

warranties of their own. Mibet Energy’s Limited Warranty covers only its

Product, and not any related items.

The warranty period begins from the delivery or pick up date from Mibet

Energy factory or warehouse. The replacement or repair of defective

components does not extend the warranty period.



Xiamen, China 361022 Fax: +86 592 6771575


15

Date post:	05-Feb-2021
Category:	Documents
Upload:	others
View:	0 times
Download:	0 times

Solar Carport System - au.mbt-energy.com · 2015-12-01 · mail on [email protected], or your...

Documents