Date post: | 21-Dec-2015 |
Category: |
Documents |
View: | 228 times |
Download: | 1 times |
Fillet Type : Constant Radius
Constant radius . Creates fillets that have a constant radius for the entire length of the fillet.
set the PropertyManager options to create these fillet types:
a.Multiple radius fillets
•Round corner fillets.
•Setback fillets
Fillet Type : Variable Radius Control Points
You can manipulate and assign radius values to the control points between the vertices of a variable radius fillet
Face Fillet Hold Lines
An edge on the part or a projected split line on a face as a boundary that determines the face fillet shape
Fillet Type : Full Round Fillet
Creates fillets that are tangent to three adjacent faces sets( with one or more faces tangent)
Fillet Property Manager : Tangent Propagation
Extends the fillet to all faces that are tangent to the selected face
fillet
• Overflow Type• Default. The system chooses one of the following options, depending on the
geometry conditions )convexity of edges being filleted and the adjacent edges, and so on(.
• Keep edge. Maintains the integrity of adjacent linear edges. However, the fillet surface is broken into separate surfaces, and in many cases the top edge of the fillet may have a dip in it.
• Keep surface. Uses the adjacent surface to trim the fillet. As a result, the fillet edge is continuous and smooth, but the adjacent edge is disturbed.
fillet
• Select Loop
To select a loop:
1- On a part, right-click an edge and choose Select Loop. A loop is selected on one face. A handle displays the direction of the loop.
2- To change the loop selection to the edges of the other connecting face, click the handle.
3- To select a loop on a face:
Select a face. Hold Ctrl and select an edge of a loop. The complete loop is selected.